AD 2000-07-14 Airworthiness Directives; McDonnell Douglas Model MD-11 Series Airplanes

Models named: MD-11 series. Read the applicability below — it usually turns on serial or part numbers too.

Model MD-11 series airplanes, as listed in McDonnell Douglas Alert Service Bulletin MD11-24A152, dated August 9, 1999; certificated in any category. Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Required as indicated, unless accomplished previously. To prevent chafing of the passenger seat wire assembly against a bracket at the lower sidewall panel due to insufficient clearance between the bracket and seat wire assembly, which could result in arcing damage to the passenger seat wire assembly and consequent smoke and fire in the main cabin, accomplish the following: Inspection, Installation, and Repair, If Necessary (a) Within 6 months after the effective date of this AD, perform a detailed visual inspection of the passenger seat wire assembly to detect chafed or damaged wires, and install protective sleeving, in accordance with McDonnell Douglas Alert Service Bulletin MD11-24A152, dated August 9, 1999. If any chafed or damaged wire is found, prior to further flight, repair in accordance with the service bulletin. Note 2: For the purposes of this AD, a detailed visual inspection is defined as: “An intensive visual examination of a specific structural area, system, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at intensity deemed appropriate by the inspector. Inspection aids such as mirror, magnifying lenses, etc., may be used. Surface cleaning and elaborate access procedures may be required.” Alternative Methods of Compliance (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Los Angeles ACO. Note 3: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO. Special Flight Permits (c) Special flight permits may be issued in accordance with §§ 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. Incorporation by Reference (d) The actions shall be done in accordance with McDonnell Douglas Alert Service Bulletin MD11-24A152, dated August 9, 1999. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Technical Publications Business Administration, Dept. C1-L51 (2-60). Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Transport Airplane Directorate, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California; or at the Office of the Federal Register 800 North Capitol Street, NW., suite 700, Washington, DC. (e) This amendment becomes effective on May 19, 2000. Issued in Renton, Washington, on April 4, 2000. Donald L. Riggin, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 00-8810 Filed 4-13-00; 8:45 am] BILLING CODE 4910-13-P