Airworthiness directives › 2000-24-14
AD 2000-24-14 Airworthiness Directives; McDonnell Douglas Model MD-11 Series Airplanes
Models named: MD-11 series. Read the applicability below — it usually turns on serial or part numbers too.
Applicability*9
Model MD-11 series airplanes, as listed in McDonnell Douglas Alert Service Bulletin MD11-24A182, dated April 3, 2000; certificated in any category. Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance
Required as indicated, unless accomplished previously. To prevent damaged electrical wires or damaged door actuation cables due to chafing by the cables during operation of the forward passenger door, which could result in electrical arcing and consequent smoke in the area above the forward passenger door, accomplish the following: Inspection (a) Except as provided by paragarph (b) of this AD, within 6 months after the effective date of this AD, perform a one-time general visual inspection of the electrical wires routed above the door actuation cables for minimum .50-inch clearance with the door in the open and closed position, damage due to chafing or electrical arcing, or damaged door actuation cables, in accordance with McDonnell Douglas Alert Service Bulletin MD11-24A182, dated April 3, 2000. Note 2: For the purposes of this AD, a general visual inspection is defined as “A visual examination of an interior or exterior area, installation, or assembly to detect obvious damage, failure, or irregularity. This level of inspection is made under normally available lighting conditions such as daylight, hangar lighting, flashlight, or drop-light, and may require removal or opening of access panels or doors. Stands, ladders, or platforms may be required to gain proximity to the area being checked.” Condition 1 (Minimum Clearance and No Chafed Electrical Wiring or Damaged Door Actuation Cables) (1) If minimum .50-inch clearance exists between the electrical wires and door actuation cables with the door in the open and closed positions, and if no chafed electrical wiring or damaged door actuation cable is detected, no further action is required by this AD. Condition 2 (Less Than Minimum Clearance, No Chafed Electrical Wiring or Damaged Door Actuation Cables) (2) If less than .50-inch clearance exists between the electrical wires and door actuation cables with the door in the open and closed positions, and if no chafed electrical wiring or damaged door actuation cable is detected, before further flight, loosen wire clamps as necessary, reposition electrical wires to provide minimum clearance, and tighten wire clamps, in accordance with the service bulletin. Condition 3 (Less Than Minimum Clearance, Chafed Electrical Wiring or Damaged Door Actuation Cables) (3) If less than .50-inch clearance exists between the electrical wires and door actuation cables with the door in the open and closed positions, and if any chafed electrical wiring or damaged door actuation cable is detected, before further flight, replace damaged electrical wires with new wires or repair damaged wires, loosen wire clamps as necessary, reposition electrical wires to provide minimum clearance, tighten wire clamps, and replace damaged door actuation cables with new cables, in accordance with the service bulletin. Exception to Inspection Required in Paragraph (a) of This AD (b) For Model MD-11 series airplanes, the inspection required by paragraph (a) of this AD is only applicable to functioning doors. For Model MD-11F series airplanes or Model MD-11 series airplanes converted to a freighter configuration, equipped with one or more disabled non-functioning doors that do not have door acuating cables, the inspection is NOT required for those disabled doors. Alternative Methods of Compliance (c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Los Angeles ACO. Note 3: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO. Special Flight Permit (d) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. Incorporation by Reference (e) The actions shall be done in accordance with McDonnell Douglas Alert Service Bulletin MD11-24A182, dated April 3, 2000. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Technical Publications Business Administration, Dept. C1-L51 (2-60). Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC. Effective Date (f) This amendment becomes effective on January 8, 2001. Issued in Renton, Washington, on November 22, 2000. Donald L. Riggin, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 00-30439 Filed 12-1-00; 8:45 am] BILLING CODE 4910-13-P
Read the original on the Federal Register →
You just looked this one up by hand
TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.
- Bring your existing list in from a spreadsheet Paste the rows straight out of Excel. Headers like C/W Date and N/A are read for you.
- A copy that works when this does not One file. No internet, no login, no this software running. For the morning something has to be produced and the computer is not cooperating.
- $5 a month, or $50 a year Up to 50 aircraft on either.
Look round a real shop first Start free
The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.
The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1