AD 2002-14-07 Airworthiness Directives; McDonnell Douglas Model MD-11 and -11F Airplanes

Models named: MD-11, -11F. Read the applicability below — it usually turns on serial or part numbers too.

Model MD-11 and -11F airplanes, as listed in Boeing Alert Service Bulletin MD11-24A036, Revision 01, dated May 21, 2001; certificated in any category. Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Required as indicated, unless accomplished previously. To prevent chafing and compression of electrical wiring at the upper track mod blocks on the flight compartment floor beams in the avionics compartment beneath the Captain's and First Officer's seats, which could result in electrical arcing and consequent smoke and/or fire in the cockpit, accomplish the following: Relocation of Mod Block Tracks (a) Within 1 year after the effective date of this AD, relocate the mod block tracks on the flight compartment floor beams in the avionics compartment beneath the Captain's and First Officer's seats, per Boeing Alert Service Bulletin MD-1124A036, Revision 01, dated May 21, 2001. Note 2: Accomplishment of the relocation per McDonnell Douglas Service Bulletin MD11-24-036, dated May 8, 1992, before the effective date of this AD, is considered acceptable for compliance with the requirements of this AD. Alternative Methods of Compliance (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Los Angeles ACO. Note 3: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO. Special Flight Permits (c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. Incorporation by Reference (d) The actions shall be done in accordance with Boeing Alert Service Bulletin MD11-24A036, Revision 01, dated May 21, 2001. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024). Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC. Effective Date (e) This amendment becomes effective on August 23, 2002. Issued in Renton, Washington, on July 2, 2002. Jeffrey E. Duven, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 02-17534 Filed 7-18-02; 8:45 am] BILLING CODE 4910-13-P