Airworthiness directives › 2002-19-11
AD 2002-19-11 Airworthiness Directives; Boeing Model 767-200 and -300 Series Airplanes Powered by Pratt & Whitney JT9D Series Engines
Models named: 767-200, -300 series. Read the applicability below — it usually turns on serial or part numbers too.
Applicability*9
Model 767-200 and -300 series airplanes powered by Pratt & Whitney JT9D series engines, certificated in any category. Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance
Required as indicated, unless accomplished previously. To prevent failure of the thrust reverser deactivation pins, which could result in deployment of the thrust reverser in flight and consequent reduced controllability of the airplane, accomplish the following: Replacement (a) Within 24 months after the effective date of this AD, replace the existing deactivation pin, pin bushing in the aft cascade mounting ring, and pin insert on each thrust reverser half, with new, improved components, according to Boeing Alert Service Bulletin 767-78A0089, Revision 1, dated May 30, 2002. Note 2: The new, improved insert flange and pin bushing does not physically preclude use of a deactivation pin having P/N 315T1604-2 or -5. However, use of deactivation pins having P/N 315T1604-2 or -5 may not prevent the thrust reversers from deploying in the event of a full powered deployment. Therefore, thrust reversers modified per this AD are required to be installed with the new, longer deactivation pins having P/N 315T1604-6, as specified in the service bulletin. Credit for Actions Accomplished According to Previous Service Bulletin Issue (b) Replacements accomplished before the effective date of this AD according to Boeing Alert Service Bulletin 767-78A0089, dated July 19, 2001, are acceptable for compliance with the corresponding action required by this AD. Alternative Methods of Compliance (c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Seattle Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Seattle ACO. Note 3: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Seattle ACO. Special Flight Permits (d) Special flight permits may be issued in accordance with §§ 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. Incorporation by Reference (e) Unless otherwise specified in this AD, the actions shall be done in accordance with Boeing Alert Service Bulletin 767-78A0089, Revision 1, dated May 30, 2002. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Boeing Commercial Airplane Group, P.O. Box 3707, Seattle, Washington 98124-2207. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC. Effective Date (f) This amendment becomes effective on November 5, 2002. Issued in Renton, Washington, on September 19, 2002. Vi L. Lipski, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 02-24405 Filed 9-30-02; 8:45 am] BILLING CODE 4910-13-P
Read the original on the Federal Register →
You just looked this one up by hand
TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.
- Bring your existing list in from a spreadsheet Paste the rows straight out of Excel. Headers like C/W Date and N/A are read for you.
- A copy that works when this does not One file. No internet, no login, no this software running. For the morning something has to be produced and the computer is not cooperating.
- $5 a month, or $50 a year Up to 50 aircraft on either.
Look round a real shop first Start free
The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.
The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1