TrackAD

Airworthiness directives › 2003-10-03

AD 2003-10-03 Airworthiness Directives; Rolls-Royce plc Model RB211 Turbofan Engines

2003-06-20
2003-05-16
39-13148
2002-NE-12-AD
Engine
—

Applicability*9

This airworthiness directive (AD) is applicable to model RB211-535E4-37, RB211-535E4-B-37 and RB211-535E4-B-75 turbofan engines with high pressure (HP) turbine disc, P/N UL10323, UL27680, and UL27681, installed. These engines are installed on, but not limited to Boeing 757 and Tupolev Tu204 airplanes. Note 1: This AD applies to each engine identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For engines that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (d) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance

Compliance with this AD is required as indicated, unless already done. To prevent machining-induced cracking of the HP turbine disc, which could cause an uncontained HP turbine disc failure and damage to the airplane, do the following: (a) Remove HP turbine discs P/Ns UL27680 and UL27681 from service before accumulating 15,000 cycles-since-new (CSN). (b) Remove HP turbine discs P/N UL10323 from service before accumulating 14,800 CSN. (c) After the effective date of this AD, do not install any HP turbine disc P/N UL27680 or UL27681 that exceeds 15,000 CSN, or any HP turbine disc P/N UL10323 that exceeds 14,800 CSN. Alternative Methods of Compliance (d) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Engine Certification Office (ECO). Operators must submit their request through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, ECO. Note 2: Information concerning the existence of approved alternative methods of compliance with this airworthiness directive, if any, may be obtained from the Engine Certification Office. Special Flight Permits (e) Special flight permits may be issued in accordance with §§ 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be done. Effective Date (f) This amendment becomes effective on June 20, 2003. Issued in Burlington, Massachusetts, on May 9, 2003. Jay J. Pardee, Manager, Engine and Propeller Directorate, Aircraft Certification Service. [FR Doc. 03-12109 Filed 5-15-03; 8:45 am] BILLING CODE 4910-13-P

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1