AD 2003-15-03 Airworthiness Directives; Boeing Model 767-200, -300, and -300F Series Airplanes

Models named: 767-200, -300, -300F series. Read the applicability below — it usually turns on serial or part numbers too.

Model 767-200, -300, and -300F series airplanes; certificated in any category; line numbers 1 through 836 inclusive. Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Required as indicated, unless accomplished previously. To prevent corrosion of the input override mechanism bearings of the lateral central control actuator, which, in the event of a subsequent jam in the pilot's aileron control system, could result in failure of the aileron override system and consequent reduced lateral controllability of the airplane, accomplish the following: Replacement (a) Within 18 months after the effective date of this AD, replace the aileron control override quadrant with a modified unit, in accordance with Boeing Alert Service Bulletin 767-27A0175, dated October 25, 2001. Note 2: This AD does not require accomplishment of the actions specified by Boeing Service Bulletin 767-27-0142. Part Installation (b) As of the effective date of this AD, no person may install, on any airplane, an aileron control override quadrant that has not been modified in accordance with the requirements of this AD. Alternative Methods of Compliance (c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Seattle Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Seattle ACO. Note 3: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Seattle ACO. Special Flight Permits (d) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. Incorporation by Reference (e) The actions shall be done in accordance with Boeing Alert Service Bulletin 767-27A0175, dated October 25, 2001. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Boeing Commercial Airplane Group, P.O. Box 3707, Seattle, Washington 98124-2207. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC. Effective Date (f) This amendment becomes effective on September 2, 2003. Issued in Renton, Washington, on July 17, 2003. Ali Bahrami, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 03-18787 Filed 7-25-03; 8:45 am] BILLING CODE 4910-13-P