AD 2005-13-29 Airworthiness Directives; Boeing Model 777-200 and -300 Series Airplanes

Models named: 777-200, -300 series. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to Boeing Model 777-200 and -300 series airplanes, certificated in any category; as identified in Boeing Alert Service Bulletin 777-27A0060, dated September 18, 2003.

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Inspection (f) Within 18 months after the effective date of this AD, inspect for installation of the tie plate for the wire bundles routed from lower section 41 into the center control stand in the flight deck, in accordance with the Accomplishment Instructions of Boeing Alert Service Bulletin 777-27A0060, dated September 18, 2003. (1) If the tie plate is found to be installed, no further action is required by this AD. (2) If the tie plate is missing, before further flight, do a detailed inspection of the wire bundles for any chafing or damage and repair if necessary, and install a tie plate in accordance with the Accomplishment Instructions of the service bulletin. Note 1: For the purposes of this AD, a detailed inspection is: “An intensive examination of a specific item, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at an intensity deemed appropriate. Inspection aids such as mirror, magnifying lenses, etc., may be necessary. Surface cleaning and elaborate procedures may be required.” Alternative Methods of Compliance (AMOCs) (g) The Manager, Seattle Aircraft Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19. Material Incorporated by Reference (h) You must use Boeing Alert Service Bulletin 777-27A0060, dated September 18, 2003, to perform the actions that are required by this AD, unless the AD specifies otherwise. The Director of the Federal Register approves the incorporation by reference of this document in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. To get copies of the service information, contact Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124-2207. To view the AD docket, go to the Docket Management Facility, U.S. Department of Transportation, 400 Seventh Street SW., room PL-401, Nassif Building, Washington, DC. To review copies of the service information, go to the National Archives and Records Administration (NARA). For information on the availability of this material at the NARA, call (202) 741-6030, or go to http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on June 14, 2005. Kevin M. Mullin, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 05-12509 Filed 6-24-05; 8:45 am] BILLING CODE 4910-13-P

This AD was prompted by a report of missing tie plates for wire bundles that are routed from lower section 41 into the center control stand in the flight deck. We are issuing this AD to prevent wire chafing, which could result in the loss of flight control, communication, navigation, and engine fire control systems. Loss of these systems could consequently result in a significant reduction of safety margins, an increase in flight crew workload, and in the case where loss of engine fire control is combined with an engine fire, could result in an uncontrollable fire.