TrackAD

Airworthiness directives › 2006-17-13

AD 2006-17-13 Airworthiness Directives; RECARO Aircraft Seating GmbH & Co. (RECARO) Model 3410 Seats

2006-09-27
2006-08-23
—
—
Airframe
—

Applicability*9

This AD applies to certain RECARO Aircraft Seats GmbH & Co. (RECARO) Model 3410 302, 303, 306, 307, 314, 316, 317, 791, 792, and 795 series seats. These seats are installed on, but not limited to, Boeing 737-200, 737-700, and 737-800 series, 747-400 series, 777-200 and 777-300 series; and Airbus Industries A319-100 series, A320-200 series, and A321-200 series airplanes.

Compliance

You are responsible for having the actions required by this AD performed within 60 days after the effective date of this AD, unless the actions have already been done. Replacing the Attachment Bolt (f) For RECARO Model 3410 302, 303, 306, 307, 314, 316, 317, 791, 792, and 795 series seats with a serial number listed in section 1.A. Effectivity of RECARO service bulletin SB-No.: 3410-25MR477, Revision 3, dated May 17, 2004, replace the seat belt attachment bolt and nut. Use section 2. Accomplishment Instructions of RECARO service bulletin SB-No.: 3410-25MR477, Revision 3, dated May 17, 2004. Alternative Methods of

Unsafe condition

This AD results from a report of short attachment bolts that don't allow enough thread to secure the locknuts properly. We are issuing this AD to prevent a seat belt from detaching due to a loose locknut and attachment bolt, which could result in injury to an occupant during emergency conditions.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1