TrackAD

Airworthiness directives › 2007-07-13

AD 2007-07-13 Airworthiness Directives; Gulfstream Aerospace LP Model Galaxy Airplanes and Model Gulfstream 200 Airplanes

2007-04-20
2007-04-05
—
—
Airframe
—

Models named: Galaxy, Gulfstream 200. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Gulfstream Model Galaxy airplanes and Model Gulfstream 200 airplanes, certificated in any category, serial numbers 004 through 056.

Compliance

Within 50 flight hours or 1 month, whichever occurs first, after the effective date of this AD, unless already done: Do the actions in paragraphs (f)(1) and (f)(2) of this AD. (1) Inspect the wiring harness for chafing and perform repairs, as applicable, according to Gulfstream Service Bulletin 200-31-301, dated January 19, 2007. (2) After doing the inspection and all applicable repairs required by paragraph (f)(1) of this AD, before further flight, inspect to make sure the wire harnesses have proper clearance and reroute/relocate wire harnesses to obtain proper clearance, as applicable, according to Gulfstream Service Bulletin 200-31-301, dated January 19, 2007. FAA AD Differences Note: This AD differs from the MCAI and/ or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Mike Borfitz, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2677; fax (425) 227-1149. Before using any AMOC approved in accordance with § 39.19 on any airplane to which the AMOC applies, notify the appropriate principal inspector in the FAA Flight Standards Certificate Holding District Office. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI Israeli Airworthiness Directive 31-07-01-12, dated February 15, 2007, and Gulfstream Service Bulletin 200-31-301, dated January 19, 2007, for related information. Material Incorporated by Reference (i) You must use Gulfstream Service Bulletin 200-31-301, dated January 19, 2007, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Gulfstream Aerospace Corporation, P.O. Box 2206, Mail Station D-25, Savannah, Georgia 31402-2206. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html . Issued in Renton, Washington, on March 23, 2007. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E7-6263 Filed 4-4-07; 8:45 am] BILLING CODE 4910-13-P

Required actions

Within 50 flight hours or 1 month, whichever occurs first, after the effective date of this AD, unless already done: Do the actions in paragraphs (f)(1) and (f)(2) of this AD. (1) Inspect the wiring harness for chafing and perform repairs, as applicable, according to Gulfstream Service Bulletin 200-31-301, dated January 19, 2007. (2) After doing the inspection and all applicable repairs required by paragraph (f)(1) of this AD, before further flight, inspect to make sure the wire harnesses have proper clearance and reroute/relocate wire harnesses to obtain proper clearance, as applicable, according to Gulfstream Service Bulletin 200-31-301, dated January 19, 2007. FAA AD Differences Note: This AD differs from the MCAI and/ or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Mike Borfitz, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2677; fax (425) 227-1149. Before using any AMOC approved in accordance with § 39.19 on any airplane to which the AMOC applies, notify the appropriate principal inspector in the FAA Flight Standards Certificate Holding District Office. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI Israeli Airworthiness Directive 31-07-01-12, dated February 15, 2007, and Gulfstream Service Bulletin 200-31-301, dated January 19, 2007, for related information. Material Incorporated by Reference (i) You must use Gulfstream Service Bulletin 200-31-301, dated January 19, 2007, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Gulfstream Aerospace Corporation, P.O. Box 2206, Mail Station D-25, Savannah, Georgia 31402-2206. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html . Issued in Renton, Washington, on March 23, 2007. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E7-6263 Filed 4-4-07; 8:45 am] BILLING CODE 4910-13-P

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1