Airworthiness directives › 2007-13-13
AD 2007-13-13 Airworthiness Directives; Empresa Brasileira de Aeronautica S.A. (EMBRAER) ERJ 170 Airplanes
Models named: ERJ 170-100 LR, -100 STD, -100 SE, -100 SU, -200 LR, -200 STD, -200 SU. Read the applicability below — it usually turns on serial or part numbers too.
Applicability*9
This AD applies to EMBRAER Model ERJ 170-100 LR, -100 STD, -100 SE, -100 SU, -200 LR, -200 STD, and -200 SU airplanes, as identified in EMBRAER Service Bulletin 170-26-0002, dated November 11, 2005; certificated in any category. Reason (d) The MCAI states that it has been found the occurrence of one case of obstruction at the cargo compartment fire extinguisher system drier metering unit (DMU) inlet, affecting the system effectiveness and, consequently, making the fire extinguishing capability at those compartments inadequate should a fire erupt. The MCAI requires installation of a debris strainer at the DMU inlet.
Compliance
Unless already done, do the following actions. Within 700 flight hours after the effective date of this AD, install a debris strainer at the DMU inlet, in accordance with the detailed instructions and procedures described in EMBRAER Service Bulletin 170-26-0002, dated November 11, 2005. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No Differences. Other FAA AD Provisions (f) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Todd Thompson, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1175; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (g) Refer to MCAI Brazilian Airworthiness Directive 2006-01-03, effective February 7, 2006; and EMBRAER Service Bulletin 170-26-0002, dated November 11, 2005; for related information. Material Incorporated by Reference (h) You must use EMBRAER Service Bulletin 170-26-0002, dated November 11, 2005, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Empresa Brasileira de Aeronautica S.A. (EMBRAER), P.O. Box 343—CEP 12.225, Sao Jose dos Campos—SP, Brazil. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. Issued in Renton, Washington, on June 18, 2007. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E7-12221 Filed 6-28-07; 8:45 am] BILLING CODE 4910-13-P
Required actions
Unless already done, do the following actions. Within 700 flight hours after the effective date of this AD, install a debris strainer at the DMU inlet, in accordance with the detailed instructions and procedures described in EMBRAER Service Bulletin 170-26-0002, dated November 11, 2005. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No Differences. Other FAA AD Provisions (f) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Todd Thompson, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1175; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (g) Refer to MCAI Brazilian Airworthiness Directive 2006-01-03, effective February 7, 2006; and EMBRAER Service Bulletin 170-26-0002, dated November 11, 2005; for related information. Material Incorporated by Reference (h) You must use EMBRAER Service Bulletin 170-26-0002, dated November 11, 2005, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Empresa Brasileira de Aeronautica S.A. (EMBRAER), P.O. Box 343—CEP 12.225, Sao Jose dos Campos—SP, Brazil. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. Issued in Renton, Washington, on June 18, 2007. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E7-12221 Filed 6-28-07; 8:45 am] BILLING CODE 4910-13-P
Read the original on the Federal Register →
You just looked this one up by hand
TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.
- Bring your existing list in from a spreadsheet Paste the rows straight out of Excel. Headers like C/W Date and N/A are read for you.
- A copy that works when this does not One file. No internet, no login, no this software running. For the morning something has to be produced and the computer is not cooperating.
- $5 a month, or $50 a year Up to 50 aircraft on either.
Look round a real shop first Start free
The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.
The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1