AD 2007-21-08 Airworthiness Directives; Hawker Beechcraft Model Hawker 800XP Airplanes

Makes named: hawker beechcraft. Models named: Hawker 800XP. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to Hawker Beechcraft Model Hawker 800XP airplanes, certificated in any category; as identified in Raytheon Service Bulletin SB 24-3772, dated February 2006.

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Inspection and Corrective Actions (f) Within 600 flight hours or 12 months after the effective date of this AD, whichever occurs first, do a detailed inspection of panel DA wiring for clearance and for signs of chafing or exposed conductors, in accordance with the Accomplishment Instructions of Raytheon Service Bulletin SB 24-3772, dated February 2006. If any wire is touching the panel, structure, or equipment, or if evidence of chafing or exposed conductors exists, before further flight, repair or replace the wires and cable ties with new ones, in accordance with the service bulletin. Note 1: For the purposes of this AD, a detailed inspection is: “An intensive examination of a specific item, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at an intensity deemed appropriate. Inspection aids such as mirror, magnifying lenses, etc., may be necessary. Surface cleaning and elaborate procedures may be required.” (g) Although Raytheon Service Bulletin SB 24-3772, dated February 2006, specifies to submit certain information to the manufacturer, this AD does not include that requirement. Alternative Methods of Compliance (AMOCs) (h)(1) The Manager, Wichita Aircraft Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19. (2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. Material Incorporated by Reference (i) You must use Raytheon Service Bulletin SB 24-3772, dated February 2006, to perform the actions that are required by this AD, unless the AD specifies otherwise. The Director of the Federal Register approved the incorporation by reference of this document in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Contact Hawker Beechcraft Corporation, 9709 East Central, Wichita, Kansas 67206, for a copy of this service information. You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html . Issued in Renton, Washington, on October 3, 2007. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E7-20138 Filed 10-15-07; 8:45 am] BILLING CODE 4910-13-P

This AD results from reports of wire bundle interference in the DA panel, chafed wire bundles, and exposed conductors. We are issuing this AD to prevent chafing of wire bundles, which could cause an electrical short and consequent loss of several functions essential for safe flight and smoke or fire in the flight compartment and main cabin.