AD 2007-23-05 Airworthiness Directives; Saab AB, Saab Aerosystems Model SAAB 2000 Airplanes

Models named: SAAB 2000. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to all Saab AB, Saab Aerosystems Model SAAB 2000 airplanes, certificated in any category, all serial numbers. Note 1: This AD requires revisions to certain operator maintenance documents to include new inspections. Compliance with these inspections is required by 14 CFR 91.403(c). For airplanes that have been previously modified, altered, or repaired in the areas addressed by these inspections, the operator may not be able to accomplish the inspections described in the revisions. In this situation, to comply with 14 CFR 91.403(c), the operator must request approval for an alternative method of compliance according to paragraph (g) of this AD. The request should include a description of changes to the required inspections that will ensure the continued operational safety of the airplane.

Unless already done, do the following actions. (1) Within 3 months after December 11, 2007 (the effective date of AD 2007-23-05), revise the ALS of the Instructions for Continued Airworthiness to incorporate the maintenance and inspection instructions in Part 1 of Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006. For all tasks identified in Part 1 of Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006, the initial compliance times start from December 11, 2007, and the repetitive inspections must be accomplished thereafter at the interval specified in Part 1 of Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006. (2) Within 12 months after December 11, 2007, revise the ALS of the Instructions for Continued Airworthiness to incorporate the CDCCLs as defined in Part 2 of Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006. (3) Except as provided by paragraph (g) of this AD: After accomplishing the actions specified in paragraphs (f)(1) and (f)(2) of this AD, no alternative inspection, inspection intervals, or CDCCLs may be used. (4) Where Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006, allows for exceptional short-term extensions, an exception is acceptable to the FAA if it is approved by the appropriate principal inspector in the FAA Flight Standards Certificate Holding District Office. New Information: Explanation of CDCCL Requirements Note 2: Notwithstanding any other maintenance or operational requirements, components that have been identified as airworthy or installed on the affected airplanes before the revision of the airworthiness limitations section (ALS), as required by paragraph (f) of this AD, do not need to be reworked in accordance with the CDCCLs. However, once the airworthiness limitations section has been revised, future maintenance actions on these components must be done in accordance with the CDCCLs. FAA AD Differences Note 3: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Shahram Daneshmandi, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1112; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI European Aviation Safety Agency Airworthiness Directive 2006-0199, dated July 11, 2006; and Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006; for related information. Material Incorporated by Reference (i) You must use Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register previously approved the incorporation by reference of this service information on December 11, 2007 (72 FR 62564, November 6, 2007). (2) For service information identified in this AD, contact Saab Aircraft AB, SAAB Aerosystems, SE 581 88, Linköping, Sweden; telephone +46 13 18 5591; fax +46 13 18 4874; e-mail saab2000.techsupport@saabgroup.com; Internet http://www.saabgroup.com. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on September 18, 2009. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E9-24542 Filed 10-14-09; 8:45 am] BILLING CODE 4910-13-P

Unless already done, do the following actions. (1) Within 3 months after December 11, 2007 (the effective date of AD 2007-23-05), revise the ALS of the Instructions for Continued Airworthiness to incorporate the maintenance and inspection instructions in Part 1 of Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006. For all tasks identified in Part 1 of Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006, the initial compliance times start from December 11, 2007, and the repetitive inspections must be accomplished thereafter at the interval specified in Part 1 of Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006. (2) Within 12 months after December 11, 2007, revise the ALS of the Instructions for Continued Airworthiness to incorporate the CDCCLs as defined in Part 2 of Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006. (3) Except as provided by paragraph (g) of this AD: After accomplishing the actions specified in paragraphs (f)(1) and (f)(2) of this AD, no alternative inspection, inspection intervals, or CDCCLs may be used. (4) Where Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006, allows for exceptional short-term extensions, an exception is acceptable to the FAA if it is approved by the appropriate principal inspector in the FAA Flight Standards Certificate Holding District Office. New Information: Explanation of CDCCL Requirements Note 2: Notwithstanding any other maintenance or operational requirements, components that have been identified as airworthy or installed on the affected airplanes before the revision of the airworthiness limitations section (ALS), as required by paragraph (f) of this AD, do not need to be reworked in accordance with the CDCCLs. However, once the airworthiness limitations section has been revised, future maintenance actions on these components must be done in accordance with the CDCCLs. FAA AD Differences Note 3: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Shahram Daneshmandi, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1112; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI European Aviation Safety Agency Airworthiness Directive 2006-0199, dated July 11, 2006; and Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006; for related information. Material Incorporated by Reference (i) You must use Saab Fuel Airworthiness Limitations 2000 LKS 009032, dated February 14, 2006, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register previously approved the incorporation by reference of this service information on December 11, 2007 (72 FR 62564, November 6, 2007). (2) For service information identified in this AD, contact Saab Aircraft AB, SAAB Aerosystems, SE 581 88, Linköping, Sweden; telephone +46 13 18 5591; fax +46 13 18 4874; e-mail saab2000.techsupport@saabgroup.com; Internet http://www.saabgroup.com. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on September 18, 2009. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E9-24542 Filed 10-14-09; 8:45 am] BILLING CODE 4910-13-P