Airworthiness directives › 2007-23-06
AD 2007-23-06 Airworthiness Directives; CTRM Aviation Sdn. Bhd. (Formerly Eagle Aircraft (Malaysia) Sdn. Bhd.) Model Eagle 150B Airplanes
Models named: Eagle 150B. Read the applicability below — it usually turns on serial or part numbers too.
Applicability*9
This AD affects Model Eagle 150B airplanes, all serial numbers, that are certificated in any category.
Compliance
Unless already done, do the following actions: (1) Within the next 25 hours time-in-service (TIS) after December 11, 2007 (the effective date of this AD), inspect the flap hinges and flap hinge support brackets for any corrosion, following CTRM Aviation Mandatory Service Bulletin SB 1126, dated July 19, 2007. (2) Before further flight, if you find any corrosion as a result of any inspection required by paragraph (f)(1) of this AD, take corrective action following CTRM Aviation Mandatory Service Bulletin SB 1126, dated July 19, 2007. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No Differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI Department of Civil Aviation Malaysia AD No. CAM AD 001-07-2007, dated July 20, 2007; and CTRM Aviation Mandatory Service Bulletin SB 1126, dated July 19, 2007, for related information. Material Incorporated by Reference (i) You must use CTRM Aviation Mandatory Service Bulletin SB 1126, dated July 19, 2007, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact CTRM Aviation Sdn. Bhd. (formerly known as Eagle Aircraft Sdn. Bhd.), Locked Bag 1028, Pejabat Pos Besar Melaka, 75150 Melaka, Malaysia; telephone: 06 317 1007; fax: 06 317 7023. (3) You may review copies at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri 64106; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. Issued in Kansas City, Missouri, on October 29, 2007. Kim Smith, Manager, Small Airplane Directorate, Aircraft Certification Service. [FR Doc. E7-21667 Filed 11-5-07; 8:45 am] BILLING CODE 4910-13-P
Required actions
Unless already done, do the following actions: (1) Within the next 25 hours time-in-service (TIS) after December 11, 2007 (the effective date of this AD), inspect the flap hinges and flap hinge support brackets for any corrosion, following CTRM Aviation Mandatory Service Bulletin SB 1126, dated July 19, 2007. (2) Before further flight, if you find any corrosion as a result of any inspection required by paragraph (f)(1) of this AD, take corrective action following CTRM Aviation Mandatory Service Bulletin SB 1126, dated July 19, 2007. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No Differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI Department of Civil Aviation Malaysia AD No. CAM AD 001-07-2007, dated July 20, 2007; and CTRM Aviation Mandatory Service Bulletin SB 1126, dated July 19, 2007, for related information. Material Incorporated by Reference (i) You must use CTRM Aviation Mandatory Service Bulletin SB 1126, dated July 19, 2007, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact CTRM Aviation Sdn. Bhd. (formerly known as Eagle Aircraft Sdn. Bhd.), Locked Bag 1028, Pejabat Pos Besar Melaka, 75150 Melaka, Malaysia; telephone: 06 317 1007; fax: 06 317 7023. (3) You may review copies at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri 64106; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. Issued in Kansas City, Missouri, on October 29, 2007. Kim Smith, Manager, Small Airplane Directorate, Aircraft Certification Service. [FR Doc. E7-21667 Filed 11-5-07; 8:45 am] BILLING CODE 4910-13-P
Read the original on the Federal Register →
You just looked this one up by hand
TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.
- Bring your existing list in from a spreadsheet Paste the rows straight out of Excel. Headers like C/W Date and N/A are read for you.
- A copy that works when this does not One file. No internet, no login, no this software running. For the morning something has to be produced and the computer is not cooperating.
- $5 a month, or $50 a year Up to 50 aircraft on either.
Look round a real shop first Start free
The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.
The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1