Airworthiness directives › 2008-09-09
AD 2008-09-09 Airworthiness Directives; DORNIER LUFTFAHRT GmbH Models 228-200, 228-201, 228-202, and 228-212 Airplanes
Applicability*9
This AD applies to Models 228-200, 228-201, 228-202, and 228-212, all serial numbers, that are: (1) Equipped with rudder control cables, part number (P/N) B-422420A00F delivered with European Aviation Safety Agency (EASA) Form One tracking number RS52074/05 after January 1, 2006 (also identified by production batch number 1141044, which is printed on the fork end next to the P/N); and (2) Certificated in any category.
Compliance
Unless already done, do the following actions: (1) Replace the rudder control cables identified in paragraph (c)(1) of this AD with FAA-approved serviceable rudder control cables following RUAG Aerospace Defence Technology Dornier 228 Alert Service Bulletin No. ASB-228-269, dated March 23, 2007, at whichever of the following occurs first: (i) Upon reaching 1,200 total hours time-in-service (TIS) on the rudder control cables identified in paragraph (c)(1) of this AD or within 30 days after June 2, 2008 (the effective date of this AD), whichever occurs later; or (ii) Within the next 3 months after June 2, 2008 (the effective date of this AD). (2) As of June 2, 2008 (the effective date of this AD), do not install any rudder control cables, P/N B-422420A00F delivered with EASA Form One tracking number RS52074/05 after January 1, 2006 (also identified by production batch number 1141044, which is printed on the fork end next to the P/N). (3) Within 30 days after doing the replacement required in paragraph (f)(1) of this AD, return the removed rudder control cables and any held as spares to the manufacturer at the address on RUAG Aerospace Defence Technology Dornier 228 Alert Service Bulletin No. ASB-228-269, dated March 23, 2007. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Staff, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI Luftfahrt-Bundesamt (LBA) AD No. D-2007-353, dated December 28, 2007, and RUAG Aerospace Defence Technology Dornier 228 Alert Service Bulletin No. ASB-228-269, dated March 23, 2007, for related information. Material Incorporated by Reference (i) You must use RUAG Aerospace Defence Technology Dornier 228 Alert Service Bulletin No. ASB-228-269, dated March 23, 2007, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact RUAG Aerospace Services, Customer Support, P.O. Box 1253, 82231 Wessling, Germany. (3) You may review copies at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri 64106; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. Issued in Kansas City, Missouri, on April 18, 2008. David R. Showers, Acting Manager, Small Airplane Directorate, Aircraft Certification Service. [FR Doc. E8-9055 Filed 4-25-08; 8:45 am] BILLING CODE 4910-13-P
Required actions
Unless already done, do the following actions: (1) Replace the rudder control cables identified in paragraph (c)(1) of this AD with FAA-approved serviceable rudder control cables following RUAG Aerospace Defence Technology Dornier 228 Alert Service Bulletin No. ASB-228-269, dated March 23, 2007, at whichever of the following occurs first: (i) Upon reaching 1,200 total hours time-in-service (TIS) on the rudder control cables identified in paragraph (c)(1) of this AD or within 30 days after June 2, 2008 (the effective date of this AD), whichever occurs later; or (ii) Within the next 3 months after June 2, 2008 (the effective date of this AD). (2) As of June 2, 2008 (the effective date of this AD), do not install any rudder control cables, P/N B-422420A00F delivered with EASA Form One tracking number RS52074/05 after January 1, 2006 (also identified by production batch number 1141044, which is printed on the fork end next to the P/N). (3) Within 30 days after doing the replacement required in paragraph (f)(1) of this AD, return the removed rudder control cables and any held as spares to the manufacturer at the address on RUAG Aerospace Defence Technology Dornier 228 Alert Service Bulletin No. ASB-228-269, dated March 23, 2007. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Staff, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI Luftfahrt-Bundesamt (LBA) AD No. D-2007-353, dated December 28, 2007, and RUAG Aerospace Defence Technology Dornier 228 Alert Service Bulletin No. ASB-228-269, dated March 23, 2007, for related information. Material Incorporated by Reference (i) You must use RUAG Aerospace Defence Technology Dornier 228 Alert Service Bulletin No. ASB-228-269, dated March 23, 2007, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact RUAG Aerospace Services, Customer Support, P.O. Box 1253, 82231 Wessling, Germany. (3) You may review copies at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri 64106; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. Issued in Kansas City, Missouri, on April 18, 2008. David R. Showers, Acting Manager, Small Airplane Directorate, Aircraft Certification Service. [FR Doc. E8-9055 Filed 4-25-08; 8:45 am] BILLING CODE 4910-13-P
Read the original on the Federal Register →
You just looked this one up by hand
TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.
- Bring your existing list in from a spreadsheet Paste the rows straight out of Excel. Headers like C/W Date and N/A are read for you.
- A copy that works when this does not One file. No internet, no login, no this software running. For the morning something has to be produced and the computer is not cooperating.
- $5 a month, or $50 a year Up to 50 aircraft on either.
Look round a real shop first Start free
The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.
The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1