AD 2008-09-21 Airworthiness Directives; Dassault Model Mystere-Falcon 50 Airplanes

Models named: Mystere-Falcon 50. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to Dassault Model Mystere-Falcon 50 airplanes, certificated in any category, serial number (S/N) 251 and S/N 253 and subsequent, without modification M3093 implemented.

Unless already done: Within 13 months after the effective date of this AD, inspect for damage of the electrical feeder bundle; repair or replace wiring, as applicable; and modify its routing as detailed in the accomplishment instructions paragraph of Dassault Service Bulletin F50-483, dated June 6, 2007, including Erratum dated July 2007. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs) : The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product : For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements : For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI European Aviation Safety Agency (EASA) Airworthiness Directive 2007-0175, dated June 28, 2007; and Dassault Service Bulletin F50-483, dated June 6, 2007, including Erratum dated July 2007; for related information. Material Incorporated by Reference (i) You must use Dassault Service Bulletin F50-483, dated June 6, 2007, including Erratum dated July 2007, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. Issued in Renton, Washington, on April 23, 2008. Ali Bahrami, Manager,Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E8-9895 Filed 5-7-08; 8:45 am] BILLING CODE 4910-13-P

Unless already done: Within 13 months after the effective date of this AD, inspect for damage of the electrical feeder bundle; repair or replace wiring, as applicable; and modify its routing as detailed in the accomplishment instructions paragraph of Dassault Service Bulletin F50-483, dated June 6, 2007, including Erratum dated July 2007. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs) : The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product : For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements : For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI European Aviation Safety Agency (EASA) Airworthiness Directive 2007-0175, dated June 28, 2007; and Dassault Service Bulletin F50-483, dated June 6, 2007, including Erratum dated July 2007; for related information. Material Incorporated by Reference (i) You must use Dassault Service Bulletin F50-483, dated June 6, 2007, including Erratum dated July 2007, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. Issued in Renton, Washington, on April 23, 2008. Ali Bahrami, Manager,Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E8-9895 Filed 5-7-08; 8:45 am] BILLING CODE 4910-13-P