Airworthiness directives › 2008-20-02
AD 2008-20-02 Airworthiness Directives; Empresa Brasileira de Aeronautica S.A. (EMBRAER) Model ERJ 170 and ERJ 190 Airplanes
Models named: ERJ 170-100 LR, -100 STD, -100 SE, -100 SU, -200 LR, -200 STD, -200 SU, ERJ 190-100 STD, -100 LR, -100 IGW. Read the applicability below — it usually turns on serial or part numbers too.
Applicability*9
This AD applies to EMBRAER Model ERJ 170-100 LR, -100 STD, -100 SE, -100 SU, -200 LR, -200 STD, and -200 SU airplanes; as identified in EMBRAER Service Bulletin 170-29-0006, Revision 01, dated February 22, 2008; and Model ERJ 190-100 STD, -100 LR, -100 IGW, -200 STD, -200 LR, and -200 IGW airplanes; as identified in EMBRAER Service Bulletin 190-29-0003, dated October 4, 2006; certificated in any category.
Compliance
Unless already done: Within 8,000 flight hours after the effective date of this AD, replace the clamps which attach the hydraulic tubes inside the wing fuel tanks with new clamps, as specified in paragraph (f)(1) or (f)(2) of this AD, as applicable; in accordance with the Accomplishment Instructions of EMBRAER Service Bulletin 170-29-0006, Revision 01, dated February 22, 2008; or 190-29-0003, dated October 4, 2006; as applicable. (1) For Model ERJ 170 airplanes: Replace any clamp having part number (P/N) PE27019RF4E with a new clamp having P/N PE27019FS4E; and any clamp having P/N PE27019RF8E with a new clamp having P/N PE27019FS8E. (2) For Model ERJ 190 airplanes: Replace any clamp having P/N PE27019RF4E with a new clamp having P/N PE27019FS4E; and any clamp having P/N PE27019RF6E with a new clamp having P/N PE27019FS6E. (3) Actions accomplished before the effective date of this AD in accordance with EMBRAER Service Bulletin 170-29-0006, dated October 4, 2006, are considered acceptable for compliance with the corresponding actions specified in paragraph (f) of this AD. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows. No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Kenny Kaulia, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2848; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI Brazilian Airworthiness Directives 2007-04-01R1 and 2007-04-02R1 (including Errata, effective December 21, 2007), both effective December 21, 2007; and EMBRAER Service Bulletins 170-29-0006, Revision 01, dated February 22, 2008; and 190-29-0003, dated October 4, 2006; for related information. Material Incorporated by Reference (i) You must use EMBRAER Service Bulletin 170-29-0006, Revision 01, dated February 22, 2008; or EMBRAER Service Bulletin 190-29-0003, dated October 4, 2006; as applicable, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Empresa Brasileira de Aeronautica S.A. (EMBRAER), P.O. Box 343—CEP 12.225, Sao Jose dos Campos—SP, Brazil. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html . Issued in Renton, Washington, on September 12, 2008. Michael Kaszycki, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E8-22205 Filed 9-26-08; 8:45 am] BILLING CODE 4910-13-P
Required actions
Unless already done: Within 8,000 flight hours after the effective date of this AD, replace the clamps which attach the hydraulic tubes inside the wing fuel tanks with new clamps, as specified in paragraph (f)(1) or (f)(2) of this AD, as applicable; in accordance with the Accomplishment Instructions of EMBRAER Service Bulletin 170-29-0006, Revision 01, dated February 22, 2008; or 190-29-0003, dated October 4, 2006; as applicable. (1) For Model ERJ 170 airplanes: Replace any clamp having part number (P/N) PE27019RF4E with a new clamp having P/N PE27019FS4E; and any clamp having P/N PE27019RF8E with a new clamp having P/N PE27019FS8E. (2) For Model ERJ 190 airplanes: Replace any clamp having P/N PE27019RF4E with a new clamp having P/N PE27019FS4E; and any clamp having P/N PE27019RF6E with a new clamp having P/N PE27019FS6E. (3) Actions accomplished before the effective date of this AD in accordance with EMBRAER Service Bulletin 170-29-0006, dated October 4, 2006, are considered acceptable for compliance with the corresponding actions specified in paragraph (f) of this AD. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows. No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Kenny Kaulia, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2848; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI Brazilian Airworthiness Directives 2007-04-01R1 and 2007-04-02R1 (including Errata, effective December 21, 2007), both effective December 21, 2007; and EMBRAER Service Bulletins 170-29-0006, Revision 01, dated February 22, 2008; and 190-29-0003, dated October 4, 2006; for related information. Material Incorporated by Reference (i) You must use EMBRAER Service Bulletin 170-29-0006, Revision 01, dated February 22, 2008; or EMBRAER Service Bulletin 190-29-0003, dated October 4, 2006; as applicable, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Empresa Brasileira de Aeronautica S.A. (EMBRAER), P.O. Box 343—CEP 12.225, Sao Jose dos Campos—SP, Brazil. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html . Issued in Renton, Washington, on September 12, 2008. Michael Kaszycki, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E8-22205 Filed 9-26-08; 8:45 am] BILLING CODE 4910-13-P
Read the original on the Federal Register →
You just looked this one up by hand
TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.
- Bring your existing list in from a spreadsheet Paste the rows straight out of Excel. Headers like C/W Date and N/A are read for you.
- A copy that works when this does not One file. No internet, no login, no this software running. For the morning something has to be produced and the computer is not cooperating.
- $5 a month, or $50 a year Up to 50 aircraft on either.
Look round a real shop first Start free
The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.
The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1