Airworthiness directives › 2008-22-05
AD 2008-22-05 Airworthiness Directives; Dassault Model Mystere-Falcon 900, Falcon 900EX, and Falcon 2000 Airplanes
Models named: Mystere-Falcon 900, Falcon 900EX, Falcon 2000. Read the applicability below — it usually turns on serial or part numbers too.
Applicability*9
This AD applies to Dassault Model Mystere-Falcon 900 airplanes from serial number (S/N) 1 to 200 inclusive; Model Falcon 900EX airplanes from S/N 1 to 129 inclusive; and Model Falcon 2000 airplanes from S/N 1 to 210 inclusive; when fitted with a third crew member control panel; certificated in any category.
Compliance
Unless already done: Within 7 months after the effective date of this AD, do a detailed inspection of the air gasper installation in the 3rd crew member control panel of the left-hand and right-hand crew closet for interference and damage, and do all applicable related corrective actions as instructed in the Accomplishment Instructions of the applicable service information listed in Table 1 of this AD. Corrective actions must be done before further flight. Table 1—Service Information Dassault Mandatory Service Bulletin— Revision— Date— F900-360 1 Feb. 15, 2008. F900EX-261 1 Feb. 15, 2008. F2000-316 1 Feb. 15, 2008. (g) Actions done before the effective date of this AD in accordance with the service information listed in Table 2 of this AD are acceptable for compliance with the requirements of paragraph (f). Table 2—Credit Service Information Dassault Service Bulletin— Date— F900-360 July 20, 2005. F900EX-261 July 20, 2005. F2000-316 July 27, 2005. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (h) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (i) Refer to MCAI European Aviation Safety Agency (EASA) Airworthiness Directive 2008-0013, dated January 24, 2008, and the service information listed in Table 1 and Table 2 of this AD, for related information. Material Incorporated by Reference (j) You must use the service information specified in Table 3 of this AD to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606; telephone 201-440-6700; Internet http://www.dassaultfalcon.com. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. Table 3—Material Incorporated by Reference Dassault Mandatory Service Bulletin— Revision— Date— F900-360 1 Feb. 15, 2008. F900EX-261 1 Feb. 15, 2008. F2000-316 1 Feb. 15, 2008. Issued in Renton, Washington, on October 10, 2008. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E8-25639 Filed 11-13-08; 8:45 am] BILLING CODE 4910-13-P
Required actions
Unless already done: Within 7 months after the effective date of this AD, do a detailed inspection of the air gasper installation in the 3rd crew member control panel of the left-hand and right-hand crew closet for interference and damage, and do all applicable related corrective actions as instructed in the Accomplishment Instructions of the applicable service information listed in Table 1 of this AD. Corrective actions must be done before further flight. Table 1—Service Information Dassault Mandatory Service Bulletin— Revision— Date— F900-360 1 Feb. 15, 2008. F900EX-261 1 Feb. 15, 2008. F2000-316 1 Feb. 15, 2008. (g) Actions done before the effective date of this AD in accordance with the service information listed in Table 2 of this AD are acceptable for compliance with the requirements of paragraph (f). Table 2—Credit Service Information Dassault Service Bulletin— Date— F900-360 July 20, 2005. F900EX-261 July 20, 2005. F2000-316 July 27, 2005. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (h) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (i) Refer to MCAI European Aviation Safety Agency (EASA) Airworthiness Directive 2008-0013, dated January 24, 2008, and the service information listed in Table 1 and Table 2 of this AD, for related information. Material Incorporated by Reference (j) You must use the service information specified in Table 3 of this AD to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606; telephone 201-440-6700; Internet http://www.dassaultfalcon.com. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. Table 3—Material Incorporated by Reference Dassault Mandatory Service Bulletin— Revision— Date— F900-360 1 Feb. 15, 2008. F900EX-261 1 Feb. 15, 2008. F2000-316 1 Feb. 15, 2008. Issued in Renton, Washington, on October 10, 2008. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E8-25639 Filed 11-13-08; 8:45 am] BILLING CODE 4910-13-P
Read the original on the Federal Register →
You just looked this one up by hand
TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.
- Bring your existing list in from a spreadsheet Paste the rows straight out of Excel. Headers like C/W Date and N/A are read for you.
- A copy that works when this does not One file. No internet, no login, no this software running. For the morning something has to be produced and the computer is not cooperating.
- $5 a month, or $50 a year Up to 50 aircraft on either.
Look round a real shop first Start free
The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.
The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1