AD 2008-22-10 Airworthiness Directives; Airbus Model A318, A319, A320, and A321 Series Airplanes

Models named: A318, A319, A320, A321 series. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to Airbus Model A318, A319, A320, and A321 series airplanes, certificated in any category, all certified models; all serial numbers which have received an original French or German (as applicable) standard airworthiness certificate or original French or German (as applicable) export certificate of airworthiness prior to February 28, 2007, and have been fitted with a cargo compartment fire extinguisher bottle installed in production, or in service by an Airbus service bulletin; except airplanes on which Airbus A318/A319/A320/A321 Maintenance Review Board Report (MRBR) Task 26.23.00/03 or 26.23.00/07 has been performed.

Within 600 flight hours after the effective date of this AD, unless already done, perform the inspection and continuity check of the cargo firing circuit and, before next flight, do applicable corrective actions, in accordance with the Accomplishment Instructions of Airbus Mandatory Service Bulletin A320-26A1068, Revision 01, dated July 19, 2007. Actions done before the effective date of this AD in accordance with Airbus Service Bulletin A320-26A1068, dated March 19, 2007, are considered acceptable for compliance with the requirements of this AD. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tim Dulin, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2141; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI European Aviation Safety Agency (EASA) Airworthiness Directive 2007-0249, dated September 24, 2007; and Airbus Mandatory Service Bulletin A320-26A1068, Revision 01, dated July 19, 2007; for related information. Material Incorporated by Reference (i) You must use Airbus Mandatory Service Bulletin A320-26A1068, Revision 01, excluding Appendix 01, dated July 19, 2007, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Airbus, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 33 33; Internet http://www.airbus.com. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on October 9, 2008. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E8-25640 Filed 11-13-08; 8:45 am] BILLING CODE 4910-13-P

Within 600 flight hours after the effective date of this AD, unless already done, perform the inspection and continuity check of the cargo firing circuit and, before next flight, do applicable corrective actions, in accordance with the Accomplishment Instructions of Airbus Mandatory Service Bulletin A320-26A1068, Revision 01, dated July 19, 2007. Actions done before the effective date of this AD in accordance with Airbus Service Bulletin A320-26A1068, dated March 19, 2007, are considered acceptable for compliance with the requirements of this AD. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tim Dulin, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2141; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI European Aviation Safety Agency (EASA) Airworthiness Directive 2007-0249, dated September 24, 2007; and Airbus Mandatory Service Bulletin A320-26A1068, Revision 01, dated July 19, 2007; for related information. Material Incorporated by Reference (i) You must use Airbus Mandatory Service Bulletin A320-26A1068, Revision 01, excluding Appendix 01, dated July 19, 2007, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Airbus, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 33 33; Internet http://www.airbus.com. (3) You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on October 9, 2008. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E8-25640 Filed 11-13-08; 8:45 am] BILLING CODE 4910-13-P