AD 2009-09-04 Airworthiness Directives; EADS-PZL “Warszawa-Okęcie” S.A. Model PZL-104 WILGA 80 Airplanes

Models named: PZL-104 WILGA 80. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to Model PZL-104 WILGA 80 airplanes, all serial numbers, certificated in any category.

Unless already done, do the following actions. (1) Within 12 years from date of manufacture or within the next two months after May 18, 2009 (the effective date of this AD), whichever occurs later, inspect the fuselage front posts for signs of corrosion following paragraph 6.A. of EADS-PZL “Warszawa-Okęcie” S.A. Mandatory Bulletin No. 10409036, dated March 18, 2009. (2) If corrosion or any corrosion damage is found during the inspection required in paragraph (f)(1) of this AD, before further flight, repair or replace any parts where corrosion or corrosion damage was found in accordance with an FAA-approved repair solution obtained from EADS-PZL “Warszawa-Okęcie” S.A. (3) Within 12 years from date of manufacture or within the next two months after May 18, 2009 (the effective date of this AD), whichever occurs later, replace the rear glass padding following paragraph 6.C. of EADS-PZL “Warszawa-Okęcie” S.A. Mandatory Bulletin No. 10409036, dated March 18, 2009. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: (1) The MCAI specifies revising the airplane maintenance program to include a repetitive inspection of the fuselage front posts. We are not including the maintenance program revision action in this AD. The Administrative Procedure Act does not permit the FAA to “bootstrap” a long-term requirement into an urgent safety of flight action where the rule becomes effective at the same time the public has the opportunity to comment. The short-term action and the long-term action are analyzed separately for justification to bypass prior public notice. (2) After issuing this AD, we may initiate further AD action (notice of proposed rulemaking followed by a final rule) to require a maintenance program revision action to do a repetitive inspection of the fuselage front posts. Credit will be given in any subsequent action for the inspection done under this AD. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to Attn: Doug Rudolph, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4059; fax: (816) 329-4090. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq. ), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI European Aviation Safety Agency (EASA) AD No.: 2009-0072, dated March 31, 2009, and EADS-PZL “Warszawa-Okęcie” S.A. Mandatory Bulletin No. 10409036, dated March 18, 2009, for related information. Material Incorporated by Reference (i) You must use EADS-PZL “Warszawa-Okęcie” S.A. Mandatory Bulletin No. 10409036, dated March 18, 2009, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact EADS-PZL “Warszawa-Okęcie” S.A., Aleja Krakowska 110/114, 00-971 Warszawa, Poland; telephone: +48 22 577 22 11; fax: +48 22 577 22 03; e-mail: eadsplz@plz.eads.net; Internet: http://www.eads.net/1024/en/businet/airbus/airbus_military/pzl/pzl.html. (3) You may review copies of the service information incorporated by reference for this AD at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the Central Region, call (816) 329-3768. (4) You may also review copies of the service information incorporated by reference for this AD at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Kansas City, Missouri on April 15, 2009. Kim Smith, Manager, Small Airplane Directorate, Aircraft Certification Service. [FR Doc. E9-9321 Filed 4-24-09; 8:45 am] BILLING CODE 4910-13-P

Unless already done, do the following actions. (1) Within 12 years from date of manufacture or within the next two months after May 18, 2009 (the effective date of this AD), whichever occurs later, inspect the fuselage front posts for signs of corrosion following paragraph 6.A. of EADS-PZL “Warszawa-Okęcie” S.A. Mandatory Bulletin No. 10409036, dated March 18, 2009. (2) If corrosion or any corrosion damage is found during the inspection required in paragraph (f)(1) of this AD, before further flight, repair or replace any parts where corrosion or corrosion damage was found in accordance with an FAA-approved repair solution obtained from EADS-PZL “Warszawa-Okęcie” S.A. (3) Within 12 years from date of manufacture or within the next two months after May 18, 2009 (the effective date of this AD), whichever occurs later, replace the rear glass padding following paragraph 6.C. of EADS-PZL “Warszawa-Okęcie” S.A. Mandatory Bulletin No. 10409036, dated March 18, 2009. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: (1) The MCAI specifies revising the airplane maintenance program to include a repetitive inspection of the fuselage front posts. We are not including the maintenance program revision action in this AD. The Administrative Procedure Act does not permit the FAA to “bootstrap” a long-term requirement into an urgent safety of flight action where the rule becomes effective at the same time the public has the opportunity to comment. The short-term action and the long-term action are analyzed separately for justification to bypass prior public notice. (2) After issuing this AD, we may initiate further AD action (notice of proposed rulemaking followed by a final rule) to require a maintenance program revision action to do a repetitive inspection of the fuselage front posts. Credit will be given in any subsequent action for the inspection done under this AD. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to Attn: Doug Rudolph, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4059; fax: (816) 329-4090. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq. ), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to MCAI European Aviation Safety Agency (EASA) AD No.: 2009-0072, dated March 31, 2009, and EADS-PZL “Warszawa-Okęcie” S.A. Mandatory Bulletin No. 10409036, dated March 18, 2009, for related information. Material Incorporated by Reference (i) You must use EADS-PZL “Warszawa-Okęcie” S.A. Mandatory Bulletin No. 10409036, dated March 18, 2009, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact EADS-PZL “Warszawa-Okęcie” S.A., Aleja Krakowska 110/114, 00-971 Warszawa, Poland; telephone: +48 22 577 22 11; fax: +48 22 577 22 03; e-mail: eadsplz@plz.eads.net; Internet: http://www.eads.net/1024/en/businet/airbus/airbus_military/pzl/pzl.html. (3) You may review copies of the service information incorporated by reference for this AD at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the Central Region, call (816) 329-3768. (4) You may also review copies of the service information incorporated by reference for this AD at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Kansas City, Missouri on April 15, 2009. Kim Smith, Manager, Small Airplane Directorate, Aircraft Certification Service. [FR Doc. E9-9321 Filed 4-24-09; 8:45 am] BILLING CODE 4910-13-P