AD 2009-11-07 Airworthiness Directives; British Aerospace Model HS 748 Airplanes

Models named: HS 748 series 2A, series 2B. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to all BAE Systems (Operations) Limited Model HS 748 series 2A and series 2B airplanes, certificated in any category.

Unless already done, within 3 months after the effective date of this AD, revise the maintenance program to incorporate the CDCCL information specified in Subsection 05-10-00, “Critical Design Configuration Control Limitations (CDCCL)—Fuel System,” of BAE Systems (Operations) Limited HS 748 Aircraft Maintenance Manual (AMM), Revision 19, dated January 15, 2008. Thereafter, no alternative CDCCL may be used unless approved as an alternative method of compliance in accordance with the procedures specified in paragraph (g)(1) of this AD. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2125; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to Mandatory Continuing Airworthiness Information (MCAI) European Aviation Safety Agency (EASA) Airworthiness Directive 2008-0125, dated July 2, 2008, and Subsection 05-10-00, “Critical Design Configuration Control Limitations (CDCCL)—Fuel system,” Revision 19, dated January 15, 2008, of BAE Systems (Operations) Limited HS 748 AMM, for related information. Material Incorporated by Reference (i) You must use Subsection 05-10-00, “Critical Design Configuration Control Limitations (CDCCL)—Fuel System,” of BAE Systems (Operations) Limited HS 748 AMM, Revision 19, dated January 15, 2008, to do the actions required by this AD, unless the AD specifies otherwise. BAE Systems (Operations) Limited HS 748 AMM, Revision 19, dated January 15, 2008, contains the following effective pages: List of Effective Pages Page title/description Page number(s) Revision number Date shown on page(s) AMM Title Page 1 19 January 15, 2008. Chapter 05 List of Effective Pages:   1-2 * January 15, 2008. Subsection 05-10-00:   1-2 * January 15, 2008. * Not shown. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact BAE Systems Regional Aircraft, 13850 McLearen Road, Herndon, Virginia 20171; telephone 703-736-1080; e-mail raebusiness@baesystems.com; Internet http://www.baesystems.com/Businesses/RegionalAircraft/index.htm. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on May 15, 2009. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E9-11997 Filed 5-27-09; 8:45 am] BILLING CODE 4910-13-P

Unless already done, within 3 months after the effective date of this AD, revise the maintenance program to incorporate the CDCCL information specified in Subsection 05-10-00, “Critical Design Configuration Control Limitations (CDCCL)—Fuel System,” of BAE Systems (Operations) Limited HS 748 Aircraft Maintenance Manual (AMM), Revision 19, dated January 15, 2008. Thereafter, no alternative CDCCL may be used unless approved as an alternative method of compliance in accordance with the procedures specified in paragraph (g)(1) of this AD. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2125; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (h) Refer to Mandatory Continuing Airworthiness Information (MCAI) European Aviation Safety Agency (EASA) Airworthiness Directive 2008-0125, dated July 2, 2008, and Subsection 05-10-00, “Critical Design Configuration Control Limitations (CDCCL)—Fuel system,” Revision 19, dated January 15, 2008, of BAE Systems (Operations) Limited HS 748 AMM, for related information. Material Incorporated by Reference (i) You must use Subsection 05-10-00, “Critical Design Configuration Control Limitations (CDCCL)—Fuel System,” of BAE Systems (Operations) Limited HS 748 AMM, Revision 19, dated January 15, 2008, to do the actions required by this AD, unless the AD specifies otherwise. BAE Systems (Operations) Limited HS 748 AMM, Revision 19, dated January 15, 2008, contains the following effective pages: List of Effective Pages Page title/description Page number(s) Revision number Date shown on page(s) AMM Title Page 1 19 January 15, 2008. Chapter 05 List of Effective Pages:   1-2 * January 15, 2008. Subsection 05-10-00:   1-2 * January 15, 2008. * Not shown. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact BAE Systems Regional Aircraft, 13850 McLearen Road, Herndon, Virginia 20171; telephone 703-736-1080; e-mail raebusiness@baesystems.com; Internet http://www.baesystems.com/Businesses/RegionalAircraft/index.htm. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on May 15, 2009. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E9-11997 Filed 5-27-09; 8:45 am] BILLING CODE 4910-13-P