AD 2009-18-15 Airworthiness Directives; Airbus Model A300, A310, and A300-600 Series Airplanes

Models named: A300, A310, A300-600 series. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to all Airbus Model A300, A310, and A300-600 series airplanes, certificated in any category.

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Note 1: This AD requires revisions to certain operator maintenance documents to include new replacements. Compliance with these inspections is required by 14 CFR 91.403(c). For airplanes that have been previously modified, altered, or repaired in the areas addressed by these replacements, the operator may not be able to accomplish the replacements described in the revisions. In this situation, to comply with 14 CFR 91.403(c), the operator must request approval for an alternative method of compliance according to paragraph (l) of this AD. The request should include a description of changes to the required replacements that will ensure the continued operational safety of the airplane. Restatement of the Requirements of AD 87-16-06 (g) For Model A300 and A310 series airplanes: Prior to the accumulation of 16,000 landings, or within the next 2,000 landings after September 3, 1987 (the effective date of AD 87-16-06), whichever occurs later, replace the nose landing gear drag strut upper attachment pin in accordance with Airbus Service Bulletin A300-32-374, Revision 1, dated July 15, 1986 (applicable to Model A300 airplanes); or A310-32-2023, Revision 2, dated November 14, 1986 (applicable to Model A310 airplanes). New Requirements of This AD ALS Revision (h) For Model A300, A310, and A300-600 series airplanes: Within 3 months after the effective date of this AD, revise the ALS of the ICA to incorporate the applicable document listed in paragraph (h)(1), (h)(2), or (h)(3) of this AD. Accomplishing the actions specified in the applicable document satisfies the requirements of paragraph A. of AD 84-02-04, amendment 39-4795. (1) For Model A300 series airplanes: Incorporate the applicable document listed in paragraph (h)(1)(i) or (h)(1)(ii) of this AD. (i) Section 05-10-00, Revision 28, dated February 27, 1998, of Chapter 05, “Service Life Limits and Maintenance Checks,” of the Airbus A300 Aircraft Maintenance Manual, except that the parts listed in Table 1 of this AD are subject to the life limits defined in the document listed in paragraph (h)(1)(ii) of this AD. (ii) “Sub-part 1-2: Life Limits,” and “Sub-part 1-3: Demonstrated Fatigue Lives” of Part 1, “Safe Life Airworthiness Limitation Items,” dated September 6, 2007, of the Airbus A300 ALS. Table 1—Parts Subject to the Life Limits Specified in the Document Identified in Paragraph (h)(1)(ii) of This AD Part No. (P/N) Part name P/N C61643-2, P/N C61643-4, P/N C61643-5 Main landing gear (MLG) shock absorber end fitting. P/N A32210001205xx Nose landing gear (NLG) pintle pin. P/N C62037-1 NLG shock absorber bottom. P/N 196-0328-501 Cross beam (Pratt & Whitney forward engine mount). (2) For Model A310 series airplanes: Incorporate “Sub-part 1-2: Life Limits,” and “Sub-part 1-3: Demonstrated Fatigue Lives” of Part 1, “Safe Life Airworthiness Limitation Items,” dated December 21, 2006, of the Airbus A310 ALS. (3) For Model A300-600 series airplanes: Incorporate “Sub-part 1-2: Life Limits,” and “Sub-part 1-3: Demonstrated Fatigue Lives” of Part 1, “Safe Life Airworthiness Limitation Items,” dated December 21, 2006, of the Airbus A300-600 ALS. Initial Compliance Times and Repetitive Inspections (i) Do the replacement at the applicable time specified in paragraph (i)(1) or (i)(2) of this AD, except as provided by paragraph (j) of this AD. The replacement must be done thereafter within the interval specified in the applicable document identified in paragraph (h)(1), (h)(2), or (h)(3) of this AD. (1) For any life limitation/task that has been complied with before the effective date of this AD in accordance with the applicable document listed in paragraph (h)(1), (h)(2), or (h)(3) of this AD, or in accordance with paragraph (g) of this AD, use the last accomplishment of each limitation/task as a starting point for accomplishing each corresponding limitation/task required by this AD. (2) For any life limitation/task that has not been complied with before the effective date of this AD in accordance with the applicable document listed in paragraphs (h)(1), (h)(2), and (h)(3) of this AD, or in accordance with paragraph (g) of this AD, the initial compliance time starts from the date of initial entry into service as defined in the applicable document. Special Compliance Times (j) For any airplane on which the history of accumulated landings is partial or unknown, or where the history of application details (airplane type, model, weight variant, etc.) is partial or unknown, with or without using the information in Airbus Service Information Letter 32-118, Revision 02, dated October 24, 2007: Parts listed in Figure 1 of this AD must be replaced at the associated compliance time. The replacement must be done thereafter at the interval specified in the applicable document(s) specified in paragraphs (h)(1), (h)(2), and (h)(3) of this AD. Note 2: Airbus Service Information Letter 32-118, Revision 02, dated October 24, 2007, provides operators with guidance on the means to assign a conservative calculated life to parts whose history of accumulated landings is partial or unknown; and to select the limitations applicable to parts whose history of application details (aircraft type, aircraft model, weight variant, etc.) is partial or unknown. BILLING CODE 4910-13-P ER22SE09.000 ER22SE09.001 ER22SE09.002 ER22SE09.003 ER22SE09.004 BILLING CODE 4910-13-C Alternative Intervals or Limits (k) Except as provided by paragraph (l) of this AD, after accomplishing the actions specified in paragraphs (h), (i), and (j) of this AD, no alternative replacements, replacement intervals, or limitations may be used. Alternative Methods of Compliance (AMOCs) (l)(1) The Manager, ANM-116, International Branch, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tom Stafford, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1622; fax (425) 227-1149. (2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD. Related Information (m) European Aviation Safety Agency (EASA) Airworthiness Directive 2007-0293, dated November 29, 2007, also addresses the subject of this AD. Material Incorporated by Reference (n) You must use the service information contained in Table 2 of this AD to do the actions required by this AD, unless the AD specifies otherwise. Table 2—Material Incorporated by Reference Document Revision Date Section 05-10-00 of Chapter 05, “Service Life Limits and Maintenance Checks,” of the Airbus A300 Aircraft Maintenance Manual 28 February 27, 1998. Airbus A300 Airworthiness Limitations Section, ALS Part 1, “Safe Life Airworthiness Limitations Items” Original September 6, 2007. Airbus A300-600 Airworthiness Limitations Section, ALS Part 1, “Safe Life Airworthiness Limitations Items” Original December 21, 2006. Airbus A310 Airworthiness Limitations Section, ALS Part 1, “Safe Life Airworthiness Limitation Items” Original December 21, 2006. Airbus Service Bulletin A300-32-374 1 July 15, 1986. Airbus Service Bulletin A310-32-2023 2 November 14, 1986. Airbus Service Bulletin A300-32-374, Revision 1, dated July 15, 1986, has the following effective pages:   Page No. Revision level shown on page Date shown on page 1, 3-8, 11 1 July 15, 1986. 2 Original April 16, 1986. (Airbus Service Bulletin A300-32-374, Revision 1, dated July 15, 1986 does not contain pages 9 and 10.) Airbus Service Bulletin A310-32-2023, Revision 2, dated November 14, 1986, has the following effective pages:   Page No. Revision level shown on page Date shown on page 1, 5-9 2 November 14, 1986 2, 4 1 July 15, 1986 3 Original April 16, 1986 Chapter 05 of Airbus A300 Aircraft Maintenance Manual has the following effective pages: List of Effective Pages Page title/description Page No.(s) Revision No. Date shown on page(s) AMM Title Page None shown None shown * February 27, 1998. Chapter 05 Record of Revisions 1-2 28 February 27, 1998. Chapter 05 Effective Pages 1-4 None shown * February 27, 1998. Chapter 05 Table of Contents 1-4 None shown * February 27, 1998. Section 05-10-00 1 None shown * February 27, 1998. * The revision number is indicated only in the Record of Revisions section of Chapter 05. (The List of Effective Pages (LOEP) for Chapter 05 of the Airbus A300 Aircraft Maintenance Manual contains the following errors: Transmittal Letter page, page 4 of the LOEP and Table of Contents sections, page 2 of Subsection 05-00-01, page 1 of Subsection 05-11-11, and Subsection 05-10-00, are not listed in the LOEP; and the LOEP also does not specify a date for the Record of Revisions page. In addition, the LOEP identifies three pages for Subsection 05-11-00, Configuration 5; however, only one page exists. The LOEP identifies three pages for Subsection 05-11-00, Configuration 9; however, those pages do not exist.) (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Airbus SAS—EAW (Airworthiness Office), 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; e-mail: account.airworth-eas@airbus.com ; Internet http://www.airbus.com. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on August 24, 2009. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E9-21033 Filed 9-21-09; 8:45 am] BILLING CODE 4910-13-P

This AD results from revisions to the Airworthiness Limitations section (ALS) of the Instructions for Continued Airworthiness (ICA) to include new or more restrictive life limits and/or replacements. We are issuing this AD to ensure the continued structural integrity of these airplanes.