AD 2009-25-06 Airworthiness Directives; Airbus Model A300 B2-1C, A300 B2-203, A300 B2K-3C, A300 B4-103, A300 B4-203, and A300 B4-2C Airplanes

Models named: A300 B2-1C, A300 B2-203, A300 B2K-3C, A300 B4-103, A300 B4-203, A300 B4-2C. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to Airbus Model A300 B2-1C, A300 B2-203, A300 B2K-3C, A300 B4-103, A300 B4-203, and A300 B4-2C airplanes, certificated in any category, as identified in Airbus Mandatory Service Bulletin A300-24-0103, Revision 03, dated February 18, 2009.

Unless already done, within 12 months after the effective date of this AD, modify the wiring of the outer fuel pump and the landing light on the LH side route 1P harness and RH side route 2P harness in accordance with the Accomplishment Instructions of Airbus Mandatory Service Bulletin A300-24-0103, Revision 03, dated February 18, 2009. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (h) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2125; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. AMOCs approved previously in accordance with AD 2007-18-02, are approved as AMOCs for the corresponding provisions of this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (i) Refer to MCAI EASA Airworthiness Directive 2009-0157, dated July 17, 2009; Airbus Service Bulletin A300-24-0103, Revision 01, dated January 11, 2007; and Airbus Mandatory Service Bulletin A300-24-0103, Revision 03, dated February 18, 2009; for related information. Material Incorporated by Reference (j) You must use Airbus Mandatory Service Bulletin A300-24-0103, Revision 03, dated February 18, 2009, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Airbus SAS—EAW (Airworthiness Office), 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; e-mail: account.airworth-eas@airbus.com ; Internet http://www.airbus.com. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on November 23, 2009. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E9-28797 Filed 12-3-09; 8:45 am] BILLING CODE 4910-13-P

Unless already done, within 12 months after the effective date of this AD, modify the wiring of the outer fuel pump and the landing light on the LH side route 1P harness and RH side route 2P harness in accordance with the Accomplishment Instructions of Airbus Mandatory Service Bulletin A300-24-0103, Revision 03, dated February 18, 2009. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (h) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2125; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. AMOCs approved previously in accordance with AD 2007-18-02, are approved as AMOCs for the corresponding provisions of this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (i) Refer to MCAI EASA Airworthiness Directive 2009-0157, dated July 17, 2009; Airbus Service Bulletin A300-24-0103, Revision 01, dated January 11, 2007; and Airbus Mandatory Service Bulletin A300-24-0103, Revision 03, dated February 18, 2009; for related information. Material Incorporated by Reference (j) You must use Airbus Mandatory Service Bulletin A300-24-0103, Revision 03, dated February 18, 2009, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Airbus SAS—EAW (Airworthiness Office), 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; e-mail: account.airworth-eas@airbus.com ; Internet http://www.airbus.com. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on November 23, 2009. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E9-28797 Filed 12-3-09; 8:45 am] BILLING CODE 4910-13-P