AD 2010-21-05 Airworthiness Directives; BAE Systems (Operations) Limited Model 4101 Airplanes

Models named: 4101. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to all BAE SYSTEMS (Operations) Limited Model 4101 airplanes, certificated in any category.

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Restatement of Requirements of AD-2008-13-02 Actions (g) Within 90 days after July 24, 2008 (the effective date of AD 2008-13-02), unless already done, do the following actions. (1) Replace the existing Propeller Limitations Placard in the cockpit with a new placard, in accordance with the Accomplishment Instructions of BAE Systems (Operations) Limited Service Bulletin J41-11-027, dated March 29, 2007. (2) Revise the BAE Jetstream Series 4100 Flight Manual (FM) to include the information in BAE Jetstream Series 4100 General Amendment G12, approved January 2007; and BAE Jetstream Series 4100 Advance Amendment Bulletin 13, approved April 4, 2007. General Amendment G12 describes a rolling take-off technique and the reduced possibility of landing with ice contaminating the wings, and adds a Gross Height/Pressure Altitude Conversion Chart. Advance Amendment Bulletin 13 introduces procedures for placing the propeller condition levers in the Flight position during all ground maneuvering. Operate the airplane according to the procedures in General Amendment G12 and Advance Amendment Bulletin 13. Note 1: This may be done by inserting copies of General Amendment G12 and Advance Amendment Bulletin 13 into the FM. When General Amendment G12 and Advance Amendment Bulletin 13 have been included in general revisions of the FM, the general revisions may be inserted in the FM, provided the relevant information in the general revision is identical to that in General Amendment G12 and Advance Amendment Bulletin 13. New Requirements of This AD Actions (h) Unless already done, do the following actions. (1) Within 6 months after the effective date of this AD, install a Propeller Speed Warning System (Modification JM41674), in accordance with Section 2 of BAE Systems (Operations) Limited Aircraft Change Information Bulletin J41-61-014, Issue 7, dated August 17, 2009. Before further flight after modification, do the actions required in paragraphs (h)(1)(i) and (h)(1)(ii) of this AD. (i) Remove the placard that was installed as required by paragraph (g)(1) of this AD. (ii) Remove BAE Jetstream Series 4100 Advance Amendment Bulletin 13, approved April 4, 2007, from the FM. (2) Within 6 months after the effective date of this AD, revise the BAE Jetstream Series 4100 FM to include information on introducing a propeller speed warning system, on airplanes that have Modification JM41674, using a method approved by the Manager, International Branch, ANM 116, Transport Airplane Directorate, FAA, or EASA (or its delegated agent). Note 2: Guidance on revising the BAE Jetstream Series 4100 FM, as required by paragraph (h)(2) of this AD, can be found in BAE Jetstream Series 4100 Particular Amendment 111, approved December 2008. FAA AD Differences Note 3: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (i) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Todd Thompson, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1175; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq. ), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (j) Refer to MCAI European Aviation Safety Agency (EASA) Airworthiness Directive 2009-0038, dated February 18, 2009; and the service information identified in Table 1 of this AD; for related information. Table 1—Service Information Service information Date BAE Jetstream Series 4100 Advance Amendment Bulletin 13 to the Jetstream Series 4100 Flight Manual April 4, 2007. BAE Jetstream Series 4100 General Amendment G12 to the Jetstream Series 4100 Flight Manual January 2007. BAE Systems (Operations) Limited Aircraft Change Information Bulletin J41-61-014, Section 2, Issue 7 August 17, 2009. BAE Systems (Operations) Limited Service Bulletin J41-11-027 March 29, 2007. Material Incorporated by Reference (k) You must use the service information contained in Table 2 of this AD to do the actions required by this AD, unless the AD specifies otherwise. Table 2—All Material Incorporated by Reference Service information Date BAE Jetstream Series 4100 Advance Amendment Bulletin 13 to the Jetstream Series 4100 Flight Manual April 4, 2007. BAE Jetstream Series 4100 General Amendment G12 to the Jetstream Series 4100 Flight Manual January 2007. BAE Systems (Operations) Limited Aircraft Change Information Bulletin J41-61-014, Section 2, Issue 7 August 17, 2009. BAE Systems (Operations) Limited Service Bulletin J41-11-027 March 29, 2007. BAE Systems (Operations) Limited Aircraft Change Information Bulletin J41-61-014, Section 2, Issue 7, contains the following effective pages: List of Effective Pages Page title/description Page number(s) Issue number Date shown on page(s) Section 2, Installer Instructions 15-50 7 August 17, 2009. (Section 1 of this document (pages 1-14) is not included.) (1) The Director of the Federal Register approved the incorporation by reference of BAE Systems (Operations) Limited Aircraft Change Information Bulletin J41-61-014, Section 2, Issue 7, dated August 17, 2009, under 5 U.S.C. 552(a) and 1 CFR part 51. (2) The Director of the Federal Register previously approved the incorporation by reference of the service information contained in Table 3 of this AD on July 24, 2008 (73 FR 34847, June 19, 2008). Table 3—Material Previously Incorporated By Reference Service information Date BAE Jetstream Series 4100 Advance Amendment Bulletin 13 to the Jetstream Series 4100 Flight Manual April 4, 2007. BAE Jetstream Series 4100 General Amendment G12 to the Jetstream Series 4100 Flight Manual January 2007. BAE Systems (Operations) Limited Service Bulletin J41-11-027 March 29, 2007. (3) For service information identified in this AD, contact BAE Systems (Operations) Limited, Customer Information Department, Prestwick International Airport, Ayrshire, KA9 2RW, Scotland, United Kingdom; telephone +44 1292 675207; fax +44 1292 675704; e-mail RApublications@baesystems.com; Internet http://www.baesystems.com/Businesses/RegionalAircraft/index.htm. (4) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221. (5) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on September 23, 2010. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 2010-25018 Filed 10-6-10; 8:45 am] BILLING CODE 4910-13-P