AD 2010-23-01 Airworthiness Directives; Piaggio Aero Industries S.p.A. Model PIAGGIO P-180 Airplanes

Models named: PIAGGIO P-180. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to Model PIAGGIO P-180 airplanes, serial numbers 1002 and 1004 through 1191, certificated in any category.

Unless already done, do the following actions: (1) Within the next 1,500 hours time-in-service (TIS) after December 10, 2010 (the effective date of this AD) or within 4 years after December 10, 2010 (the effective date of this AD), whichever occurs first, do the following: (i) Remove the left-hand (LH) and the right-hand (RH) elevators and do all of the inspections and corrective actions following the Accomplishment Instructions in Parts A, B, C, D, and E of PIAGGIO AERO INDUSTRIES S.p.A. Service Bulletin (MANDATORY) N.: SB-80-0262, Revision 2, dated March 17, 2010. (ii) Reinstall the LH and RH elevators and do the final checks following the Accomplishment Instructions, Part F, of PIAGGIO AERO INDUSTRIES S.p.A. Service Bulletin (MANDATORY) N.: SB-80-0262 Revision 2, dated March 17, 2010. (2) We will allow “unless already done” credit for inspections and corrective actions already done, before the effective date of this AD, following PIAGGIO AERO INDUSTRIES S.p.A. Service Bulletins (MANDATORY) N.: SB-80-0262, original issue dated September 24, 2009; or Revision 1 dated December 23, 2009, for compliance with the requirements of this AD. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to Attn: Sarjapur Nagarajan, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4145; fax: (816) 329-4090; e-mail: sarjapur.nagarajan@faa.gov. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, a federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB Control Number. The OMB Control Number for this information collection is 2120-0056. Public reporting for this collection of information is estimated to be approximately 5 minutes per response, including the time for reviewing instructions, completing and reviewing the collection of information. All responses to this collection of information are mandatory. Comments concerning the accuracy of this burden and suggestions for reducing the burden should be directed to the FAA at: 800 Independence Ave. SW., Washington, DC 20591, Attn: Information Collection Clearance Officer, AES-200. Related Information (h) Refer to MCAI EASA AD No.: 2010-0124 (Correction: June 22, 2010), dated June 22, 2010; and PIAGGIO AERO INDUSTRIES S.p.A. Service Bulletin (MANDATORY) N.: SB-80-0262, Revision 2, dated March 17, 2010, for related information. Material Incorporated by Reference (i) You must use PIAGGIO AERO INDUSTRIES S.p.A. Service Bulletin (MANDATORY) N.: SB-80-0262, Revision 2, dated March 17, 2010, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Piaggio Aero Industries S.p.a., Via Cibrario, 4-16154 Genoa, Italy; phone: +39 010 6481 800; fax: +39 010 6481 374; e-mail: tech.support@piaggioaero.it; Internet: http://www.piaggioaero.com. (3) You may review copies of the referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call 816-329-4148. (4) You may also review copies of the service information incorporated by reference for this AD at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Kansas City, Missouri, on October 21, 2010. Christina L. Marsh, Acting Manager, Small Airplane Directorate, Aircraft Certification Service. [FR Doc. 2010-27456 Filed 11-4-10; 8:45 am] BILLING CODE 4910-13-P

Unless already done, do the following actions: (1) Within the next 1,500 hours time-in-service (TIS) after December 10, 2010 (the effective date of this AD) or within 4 years after December 10, 2010 (the effective date of this AD), whichever occurs first, do the following: (i) Remove the left-hand (LH) and the right-hand (RH) elevators and do all of the inspections and corrective actions following the Accomplishment Instructions in Parts A, B, C, D, and E of PIAGGIO AERO INDUSTRIES S.p.A. Service Bulletin (MANDATORY) N.: SB-80-0262, Revision 2, dated March 17, 2010. (ii) Reinstall the LH and RH elevators and do the final checks following the Accomplishment Instructions, Part F, of PIAGGIO AERO INDUSTRIES S.p.A. Service Bulletin (MANDATORY) N.: SB-80-0262 Revision 2, dated March 17, 2010. (2) We will allow “unless already done” credit for inspections and corrective actions already done, before the effective date of this AD, following PIAGGIO AERO INDUSTRIES S.p.A. Service Bulletins (MANDATORY) N.: SB-80-0262, original issue dated September 24, 2009; or Revision 1 dated December 23, 2009, for compliance with the requirements of this AD. FAA AD Differences Note: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (g) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to Attn: Sarjapur Nagarajan, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4145; fax: (816) 329-4090; e-mail: sarjapur.nagarajan@faa.gov. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, a federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB Control Number. The OMB Control Number for this information collection is 2120-0056. Public reporting for this collection of information is estimated to be approximately 5 minutes per response, including the time for reviewing instructions, completing and reviewing the collection of information. All responses to this collection of information are mandatory. Comments concerning the accuracy of this burden and suggestions for reducing the burden should be directed to the FAA at: 800 Independence Ave. SW., Washington, DC 20591, Attn: Information Collection Clearance Officer, AES-200. Related Information (h) Refer to MCAI EASA AD No.: 2010-0124 (Correction: June 22, 2010), dated June 22, 2010; and PIAGGIO AERO INDUSTRIES S.p.A. Service Bulletin (MANDATORY) N.: SB-80-0262, Revision 2, dated March 17, 2010, for related information. Material Incorporated by Reference (i) You must use PIAGGIO AERO INDUSTRIES S.p.A. Service Bulletin (MANDATORY) N.: SB-80-0262, Revision 2, dated March 17, 2010, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Piaggio Aero Industries S.p.a., Via Cibrario, 4-16154 Genoa, Italy; phone: +39 010 6481 800; fax: +39 010 6481 374; e-mail: tech.support@piaggioaero.it; Internet: http://www.piaggioaero.com. (3) You may review copies of the referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call 816-329-4148. (4) You may also review copies of the service information incorporated by reference for this AD at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Kansas City, Missouri, on October 21, 2010. Christina L. Marsh, Acting Manager, Small Airplane Directorate, Aircraft Certification Service. [FR Doc. 2010-27456 Filed 11-4-10; 8:45 am] BILLING CODE 4910-13-P