AD 2010-23-18 Airworthiness Directives; Airbus Model A380-800 Series Airplanes

Models named: A380-841, -842, -861. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to Airbus Model A380-841, -842, and -861 airplanes, certificated in any category, with serial numbers 15, 17, 19, 20, 21, and 22.

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Inspection and Corrective Actions (g) Within 3 months after the effective date of this AD: Do a one-time detailed visual inspection to ensure the correct installation of the OHDS sensing elements and insulation muffs, in accordance with the Accomplishment Instructions of Airbus Mandatory Service Bulletin A380-36-8009, including Service Bulletin Report Sheet, dated December 7, 2009. (h) If, during any inspection required by paragraph (g) of this AD, any sensing element or insulation muff is found to have been installed incorrectly, before further flight, bring the installation into compliant configuration, in accordance with Airbus Mandatory Service Bulletin A380-36-8009, dated December 7, 2009. (i) Submit a report of the findings (both positive and negative) of the inspection required by paragraph (g) of this AD to Airbus, Customer Services Directorate, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 33 33; fax +33 5 61 93 28 06; e-mail sb.reporting@airbus.com; Internet http://www.airbus.com , at the applicable time specified in paragraph (i)(1) or (i)(2) of this AD. The report must include the inspection results, a description of any discrepancies found, the airplane serial number, and the number of landings and flight hours on the airplane. (1) If the inspection was done on or after the effective date of this AD: Submit the report within 30 days after the inspection. (2) If the inspection was done before the effective date of this AD: Submit the report within 30 days after the effective date of this AD. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (j) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Todd Thompson, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1175; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq. ), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (k) Refer to Mandatory Continuing Airworthiness Information (MCAI) European Aviation Safety Agency (EASA) Airworthiness Directive 2009-0265, dated December 16, 2009, and Airbus Mandatory Service Bulletin A380-36-8009, dated December 7, 2009, for related information. Material Incorporated by Reference (l) You must use Airbus Mandatory Service Bulletin A380-36-8009, including Service Bulletin Report Sheet, dated December 7, 2009, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Airbus SAS—EANA (Airworthiness Office); 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 562 110 253; Fax +33 562 110 307; e-mail account.airworth-A380@airbus.com; Internet http://www.airbus.com. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on October 26, 2010. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 2010-28166 Filed 11-8-10; 8:45 am] BILLING CODE 4910-13-P