TrackAD

Airworthiness directives › 2010-25-03

AD 2010-25-03 Airworthiness Directives; Airbus Model A300 Series Airplanes

2011-01-11
2010-12-07
—
—
Airframe
—

Models named: A300 B2-1A, B2-1C, B4-2C, B2K-3C, B4-103, B2-203, B4-203. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Airbus Model A300 B2-1A, B2-1C, B4-2C, B2K-3C, B4-103, B2-203, and B4-203 airplanes, certificated in any category, all serial numbers.

Compliance

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Actions (g) Within 2,500 flight hours after the effective date of this AD, do a detailed visual inspection for metallic particles, cracks, scratches, and missing materials of the THSA upper attachment and screw shaft, in accordance with the Accomplishment Instructions of Airbus Mandatory Service Bulletin A300-27-0203, dated June 8, 2009. Repeat the inspection thereafter at intervals not to exceed 2,500 flight hours. (h) If during any inspection required by paragraph (g) of this AD, any metallic particle, crack, scratch, or missing material is found, before further flight, contact Airbus to obtain approved corrective action instructions, and accomplish those instructions accordingly. (i) Doing the corrective actions specified in paragraph (h) of this AD is not a terminating action for the repetitive inspections required by paragraph (g) of this AD. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (j) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2125; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq. ), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (k) Refer to MCAI European Aviation Safety Agency Airworthiness Directive 2010-0019, dated February 5, 2010; and Airbus Mandatory Service Bulletin A300-27-0203, dated June 8, 2009; for related information. Material Incorporated by Reference (l) You must use Airbus Mandatory Service Bulletin A300-27-0203, excluding Appendix 01, dated June 8, 2009, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Airbus SAS-EAW (Airworthiness Office), 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; e-mail: account.airworth-eas@airbus.com; Internet http://www.airbus.com. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on October 22, 2010. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 2010-30309 Filed 12-6-10; 8:45 am] BILLING CODE 4910-13-P

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1