AD 2011-10-14 Airworthiness Directives; DASSAULT AVIATION Model MYSTERE-FALCON 50 Airplanes

Models named: MYSTERE-FALCON 50. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to DASSAULT AVIATION Model MYSTERE-FALCON 50 airplanes, certificated in any category, all serial numbers.

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Restatement of Requirements of AD 2010-24-08 Actions (g) Within 7 days after December 9, 2010 (the effective date of AD 2010-24-08), do a general visual inspection for correct installation (as defined in Dassault Service Bulletin F50-515, dated October 12, 2010) of the emergency brake system number 2, in accordance with the Accomplishment Instructions of Dassault Service Bulletin F50-515, dated October 12, 2010, except that work required by this AD can only be done by persons prescribed in 14 CFR 43.3 and 43.7. (h) If the emergency brake system number 2 is found installed incorrectly during the inspection required by paragraph (g) of this AD: Before further flight, install the emergency brake system number 2 correctly, in accordance with the Accomplishment Instructions of Dassault Service Bulletin F50-515, dated October 12, 2010. New Requirements of This AD (i) Within 7 months after the effective date of this AD, paint the pipe ends of the emergency brake system #2 and related unions, in accordance with paragraph 2.C. of the Accomplishment Instructions of Dassault Service Bulletin F50-515, dated October 12, 2010. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: (1) European Aviation Safety Agency (EASA) AD 2010-0208-E, dated October 12, 2010, has a compliance time of “before the next flight after the effective date of this AD.″ This AD requires that the actions be done within 7 days after the effective date of AD 2010-24-08. (2) EASA AD 2010-0208-E, dated October 12, 2010, allows the flightcrew to inspect the emergency brake system number 2 specified in accordance with Dassault Service Bulletin F50-515, dated October 12, 2010. However, this AD requires the inspection to be performed by certificated maintenance personnel. Other FAA AD Provisions (j) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. Related Information (k) Refer to MCAI EASA AD 2010-0208-E, dated October 12, 2010; and Dassault Service Bulletin F50-515, dated October 12, 2010; for related information. Material Incorporated by Reference (l) You must use Dassault Service Bulletin F50-515, dated October 12, 2010, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register previously approved the incorporation by reference of Dassault Service Bulletin F50-515, dated October 12, 2010, on December 9, 2010 (75 FR 71530, November 24, 2010). (2) For service information identified in this AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606; telephone 201-440-6700; Internet http://www.dassaultfalcon.com. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on April 28, 2011. Kalene C. Yanamura, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 2011-11329 Filed 5-12-11; 8:45 am] BILLING CODE 4910-13-P