AD 2011-22-02 Airworthiness Directives; Airbus Airplanes

Models named: A300 B4-601, B4-603, B4-620, B4-622, A300 B4-605R, B4-622R, A300 F4-605R, F4-622R, A300 C4-605R Variant F, A310-203. Read the applicability below — it usually turns on serial or part numbers too.

This AD applies to all Airbus Model A300 B4-601, B4-603, B4-620, and B4-622 airplanes; Model A300 B4-605R and B4-622R airplanes; Model A300 F4-605R and F4-622R airplanes; Model A300 C4-605R Variant F airplanes; and Model A310-203, -204, -221, -222, -304, -322, -324, and -325 airplanes; certificated in any category.

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Actions (g) Within 30 months or 4,000 flight hours after the effective date of this AD, whichever occurs first: Modify the electrical installation in the pylon/wing interface on the left-hand and right-hand side by doing a general visual inspection of wires for damage and doing all applicable repairs, replace the cable tie with lacing tape, improve the electrical installation at the level of the electrical ramp, and improve the segregation of both routes of the LPV channels 1 and 2 between LPV connector and ramp; in accordance with the Accomplishment Instructions of Airbus Mandatory Service Bulletin A300-24-6106, excluding Appendix 01, dated March 31, 2010 (for Airbus Model A300 B4-600, B4-600R, and F4-600R series airplanes, and Model C4-605R Variant F airplanes); or Airbus Mandatory Service Bulletin A310-24-2106, Revision 01, including Appendix 01, dated April 4, 2011 (for Airbus Model A310 series airplanes). Do all applicable repairs before further flight. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (h) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2125; fax (425) 227-1149. Information may be e-mailed to: 9-ANM-11-AMOC-REQUESTS@faa.gov . Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. Related Information (i) Refer to MCAI European Aviation Safety Agency Airworthiness Directive 2010-0178R1, excluding Appendix 01, dated May 20, 2011; Airbus Mandatory Service Bulletin A300-24-6106, dated March 31, 2010; and Airbus Mandatory Service Bulletin A310-24-2106, Revision 01, including Appendix 01, dated April 4, 2011; for related information. Material Incorporated by Reference (j) You must use Airbus Mandatory Service Bulletin A300-24-6106, excluding Appendix 01, dated March 31, 2010; or Airbus Mandatory Service Bulletin A310-24-2106, Revision 01, including Appendix 01, dated April 4, 2011; as applicable; to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact Airbus SAS—EAW (Airworthiness Office), 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; e-mail account.airworth-eas@airbus.com ; Internet http://www.airbus.com . (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on October 11, 2011. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 2011-27005 Filed 10-24-11; 8:45 am] BILLING CODE 4910-13-P