Airworthiness directives › 2011-24-10
AD 2011-24-10 Airworthiness Directives; Bombardier, Inc. Airplanes
Models named: DHC-8-201, -202. Read the applicability below — it usually turns on serial or part numbers too.
Applicability*9
This AD applies to Bombardier, Inc. Model DHC-8-201, and -202 airplanes; certificated in any category; serial numbers 003 and subsequent with FAA Supplemental Type Certificate (STC) ST00753NY (Transport Canada Civil Aviation (TCCA) STC SA97-106) installed.
Compliance
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Cargo Conversion System and Combi Abrasion Protection System Removal (g) Within 60 days after the effective date of this AD: Remove the DECA Aviation Engineering Limited Combi Abrasion Protection System configurations previously installed by using FAA STC ST00753NY (TCCA STC SA97-106), in accordance with the removal instructions specified in DECA Engineering Order EI4394, Revision 2, dated February 5, 2011. Parts Installation (h) As of the effective date of this AD, no person may install the DECA Aviation Engineering Limited Combi Abrasion Protection Systems configurations by using FAA STC ST00753NY (TCCA STC SA97-106), on any airplane. Credit for Actions Accomplished in Accordance With Previous Service Information (i) Removing the DECA Combi Abrasion Protection System in accordance with DECA Engineering Order EI4394, Revision 1, dated January 13, 2011, before the effective date of this AD is acceptable for compliance with the corresponding removal required by paragraph (g) of this AD. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: This FAA AD only applies to Model DHC-8 Series 200 airplanes with Supplemental Type Certificate (STC) FAA ST00753NY (TCCA STC SA97-106) installed. The FAA has not approved any STC equivalent to Model DHC-8 series 100 TCCA STC SA00-107. Other FAA AD Provisions (j) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue Suite 410, Westbury, New York 11590; telephone (516) 228-7300; fax (516) 794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. Related Information (k) Refer to Mandatory Continuing Airworthiness Information (MCAI) Transport Canada Civil Aviation (TCCA), Airworthiness Directive CF-2011-02, dated February 1, 2011; and DECA Engineering Order EI4394, Revision 2, dated February 5, 2011; for related information. Material Incorporated by Reference (l) You must use DECA Engineering Order EI4394, Revision 2, dated February 5, 2011, to do the actions required by this AD, unless the AD specifies otherwise. (1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. (2) For service information identified in this AD, contact DECA Aviation Engineering Limited, 7050 Telford Way Suite 200, Mississauga, Ontario, Canada L5S 1V7; telephone (905) 405-1371; fax (905) 405-1373; email inquiry@deca-aviation.com; Internet http://www.deca-aviation.com. (3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington. For information on the availability of this material at the FAA, call (425) 227-1221. (4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html. Issued in Renton, Washington, on November 10, 2011. Kalene C. Yanamura, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 2011-30232 Filed 11-30-11; 8:45 am] BILLING CODE 4910-13-P
Read the original on the Federal Register →
You just looked this one up by hand
TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.
- Bring your existing list in from a spreadsheet Paste the rows straight out of Excel. Headers like C/W Date and N/A are read for you.
- A copy that works when this does not One file. No internet, no login, no this software running. For the morning something has to be produced and the computer is not cooperating.
- $5 a month, or $50 a year Up to 50 aircraft on either.
Look round a real shop first Start free
The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.
The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1