TrackAD

Airworthiness directives › 2012-09-08

AD 2012-09-08 Airworthiness Directives; The Boeing Company Airplanes

2012-06-18
2012-05-14
39-17043
FAA-2011-0993
Airframe
—

Models named: 767-200, -300 series. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to The Boeing Company Model 767-200 and -300 series airplanes, certificated in any category, as identified in Boeing Alert Service Bulletin 767-53A0139, dated November 12, 2009. Note 1 to paragraph (c) of this AD: Supplemental Type Certificate (STC) ST01920SE ( http://rgl.faa.gov/Regulatory_and_Guidance_Library/rgstc.nsf/0/082838ee177dbf62862576a4005cdfc0/$FILE/ST01920SE.pdf ) does not affect the ability to accomplish the actions required by this AD. Therefore, for airplanes on which STC ST01920SE is installed, a “change in product” alternative method of compliance (AMOC) approval request is not necessary to comply with the requirements of 14 CFR 39.17.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as provided by paragraph (h) of this AD: Before the accumulation of 43,000 total flight cycles, or within 1,600 flight cycles after the effective date of this AD, whichever occurs later, do detailed, low-frequency eddy current, and mid-frequency eddy current inspections for cracking of the aft pressure bulkhead at STA 1582, in accordance with the Accomplishment Instructions of Boeing Alert Service Bulletin 767-53A0139, dated November 12, 2009. If any crack is found, before further flight, replace the bulkhead as required by paragraph (h) of this AD, or repair the crack in accordance with the Accomplishment Instructions of Boeing Alert Service Bulletin 767-53A0139, dated November 12, 2009, and repeat the inspections thereafter at intervals not to exceed 1,600 flight cycles. If no crack is found, repeat the inspections thereafter at intervals not to exceed 1,600 flight cycles. Accomplishing the inspections required by this paragraph terminates the inspections required by paragraph (f) of AD 2005-03-11, Amendment 39-13967 (70 FR 7174, February 11, 2005), corrected on March 11, 2005 (70 FR 12119).

Unsafe condition

This AD was prompted by reports of multiple site damage cracks in the radial web lap and tear strap splices of the aft pressure bulkhead at station (STA) 1582 due to fatigue. We are issuing this AD to prevent fatigue cracking of the aft pressure bulkhead, which could result in rapid decompression of the airplane and possible damage or interference with the airplane control systems that penetrate the bulkhead, and consequent loss of controllability of the airplane.

Affected ADs

Certain requirements of this AD affect certain requirements of AD 2004-05-16, Amendment 39-13511 (69 FR 10917, March 9, 2004), and AD 2005-03-11, Amendment 39-13967 (70 FR 7174, February 11, 2005), corrected on March 11, 2005 (70 FR 12119).

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1