TrackAD

Airworthiness directives › 2012-10-06

AD 2012-10-06 Airworthiness Directives; Saab AB, Saab Aerosystems Airplanes

2012-06-25
2012-05-21
—
—
Airframe
—

Models named: SAAB 2000. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to all Saab AB, Saab Aerosystems Model SAAB 2000 airplanes; certificated in any category.

Compliance

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

Required actions

Within 24 months after the effective date of this AD, do a detailed inspection for corrosion of the electrical and electronics installation, at the locations specified in and in accordance with the Accomplishment Instructions of SAAB Service Bulletin 2000-92-005, Revision 01, dated March 1, 2011; and SAAB Service Bulletin 2000-92-006, Revision 01, dated August 18, 2010. These inspections do not need to be accomplished concurrently.

Unsafe condition

This AD was prompted by reports that environmentally friendly de-icing agents used on certain electrical connectors and braids could cause corrosion damage. We are issuing this AD to detect and correct corrosion of critical system wiring, which could result in arcing and, in combination with other factors, a fire and consequent damage to the airplane.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1