TrackAD

Airworthiness directives › 2013-03-21

AD 2013-03-21 Airworthiness Directives; Pratt & Whitney Canada Corp. Turboshaft Engines

2013-03-26
2013-02-19
—
—
Engine
—

Applicability*9

This AD applies to Pratt & Whitney Canada Corp. (P&WC) model PW206B, PW206B2, PW206C, PW207C, PW207D, PW207D1, PW207D2, and PW207E turboshaft engines.

Compliance

(1) For any PT disk P/N 3044188-01 that is listed by serial number (S/N) in Table 1 of P&WC Alert Service Bulletin (ASB) No. PW200-72-A28311, Revision 2, dated July 24, 2012, and, that is installed or that had previously been installed with Turbomachinery Assembly P/N 3058588 installation, do the following: (i) Remove the PT disk P/N 3044188-01 from service before it reaches 10,000 cycles-since-new (CSN). (ii) Re-identify the PT disk to P/N 3072542-01, at the next engine shop visit, not to exceed 10,000 CSN on the PT disk, before reinstalling it in any engine. Use paragraphs 3.B.(1) through 3.B.(1)(b) 4 of the Accomplishment Instructions of P&WC ASB No. PW200-72-A28311, Revision 2, dated July 24, 2012, to do the re-identification. (iii) After re-identification of the PT disk to P/N 3072542-01, retain the total cycles accumulated as P/N 3044188-01. The cycles remaining on the re-identified P/N 3072542-01 PT disk must be calculated using the difference between the published life limit of P/N 3072542-01 and the total number of cycles accumulated as P/N 3044188-01. The maximum in-service life of PT disk, P/N 3072542-01, is 10,000 CSN. (2) After the effective date of this AD, do not install any PT disk, P/N 3044188-01, that is listed in Table 1 of P&WC ASB No. PW200-72-A28311, Revision 2, dated July 24, 2012, in any engine with Turbomachinery Assembly P/N 3058588 installation, unless the PT disk has been re-identified to P/N 3072542-01. Use paragraphs 3.B.(1) through 3.B.(1)(b) 4 of the Accomplishment Instructions of P&WC ASB No. PW200-72-A28311, Revision 2, dated July 24, 2012, to do the PT disk re-identification.

Required actions

You may take credit for the re-identification of the PT disk that is required by this AD if you performed the re-identification before the effective date of this AD using P&WC ASB No. PW200-72-A28311, dated March 1, 2012, or P&WC ASB No. PW200-72-A28311, Revision 1, dated March 22, 2012.

Unsafe condition

Unless already done, do the following actions.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1