Airworthiness directives › 2013-22-12
AD 2013-22-12 Airworthiness Directives; DG Flugzeugbau GmbH Gliders
Applicability*9
This AD applies to DG Flugzeugbau GmbH DG-800A, DG-800B, and DG-500MB gliders, all serial numbers, certificated in any category.
Compliance
Unless already done, do the actions in paragraphs (f)(1) and (f)(2) of this AD: (1) Within 10 days after November 18, 2013 (the effective date of this AD), inspect to determine if an unmodified starter control unit is installed. If an unmodified starter control unit is installed, remove the unit and replace it with a modified unit. Do the removal and replacement following the Instructions section of DG Flugzeugbau GmbH Technical note No. 800/42, 500/06 (co-published as one document), dated May 29, 2013. (2) As of November 18, 2013 (the effective date of this AD), do not install any starter motor control unit unless it has been modified and labeled with placard “MS.”
Required actions
The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Jim Rutherford, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4165; fax: (816) 329-4090; email: jim.rutherford@faa.gov . Before using any approved AMOC on any glider to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
Unsafe condition
This AD was prompted by mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as a defective starter motor control, which could activate the starter motor without pressing the starter button. We are issuing this AD to prevent sudden propeller rotation, which could result in injury to the pilot and/or other persons.
Affected ADs
None.
Read the original on the Federal Register →
You just looked this one up by hand
TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.
- Bring your existing list in from a spreadsheet Paste the rows straight out of Excel. Headers like C/W Date and N/A are read for you.
- A copy that works when this does not One file. No internet, no login, no this software running. For the morning something has to be produced and the computer is not cooperating.
- $5 a month, or $50 a year Up to 50 aircraft on either.
Look round a real shop first Start free
The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.
The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1