TrackAD

Airworthiness directives › 2014-15-14

AD 2014-15-14 Airworthiness Directives; the Boeing Company Airplanes

Superseded. This directive was replaced by AD 2022-17-03. Work to the current one.
2014-09-09
2014-08-05
—
—
Airframe
2022-17-03

Models named: 747-100, 747-100B, 747-100B SUD, 747-200B, 747-200C, 747-200F, 747-300, 747-400, 747-400D, 747-400F. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to The Boeing Company Model 747-100, 747-100B, 747-100B SUD, 747-200B, 747-200C, 747-200F, 747-300, 747-400, 747-400D, 747-400F, 747SR, and 747SP series airplanes; certificated in any category; as identified in Boeing Service Bulletin 747-28-2315, dated January 11, 2012.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Within 72 months after the effective date of this AD, do the actions specified in paragraphs (g)(1) and (g)(2) of this AD, in accordance with the Accomplishment Instructions of Boeing Service Bulletin 747-28-2315, dated January 11, 2012. (1) Do either a general visual inspection or ultrasonic non-destructive test of the left- and right-hand wing fuel tank access doors to determine whether impact-resistant access doors are installed in the correct locations. If any standard access door is found, before further flight, replace with an impact-resistant access door, in accordance with the Accomplishment Instructions of Boeing Service Bulletin 747-28-2315, dated January 11, 2012. (2) Do a general visual inspection of the left- and right-hand wing fuel tank impact-resistant access doors and adjacent wing skin to verify stencils and index markers are applied. If a stencil or index marker is missing, before further flight, apply a stencil or index marker, as applicable, in accordance with the Accomplishment Instructions of Boeing Service Bulletin 747-28-2315, dated January 11, 2012.

Unsafe condition

This AD was prompted by report of a standard access door installed instead of an impact-resistant access door and stencils missing from some impact-resistant access doors and adjacent wing skin. We are issuing this AD to prevent foreign object penetration of the fuel tank, which could cause a fuel leak near an ignition source (e.g., hot brakes or engine exhaust nozzle), consequently leading to a fuel-fed fire.

Affected ADs

This AD replaces AD 89-12-10, Amendment 39-6230 (Docket No. 88-NM-57-AD; 54 FR 23643, June 2, 1989).

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1