TrackAD

Airworthiness directives › 2014-24-06

AD 2014-24-06 Airworthiness Directives; The Boeing Company Airplanes

2015-01-09
2014-12-05
39-18039
FAA-2014-0168
Airframe
—

Models named: 787-8. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to The Boeing Company Model 787-8 airplanes, certificated in any category, with Goodrich Model 2787 seat assemblies installed; as identified in Boeing Service Bulletin B787-81205-SB250027-00, Issue 001, dated January 14, 2014.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Within 24 months after the effective date of this AD: Replace the existing restraint attachment fitting on the standard attendant seat with a new, improved attachment fitting, in accordance with the Accomplishment Instructions of Boeing Service Bulletin B787-81205-SB250027-00, Issue 001, dated January 14, 2014; and UTC Aerospace Systems Service Bulletin 2787-25-006, Revision B, dated July 10, 2013.

Unsafe condition

This AD was prompted by failure during testing of the anchor attachment on the occupant restraint system on the standard attendant seat due to an understrength attachment fitting. We are issuing this AD to prevent failure of the restraint attachment fitting of the attendant seat during an emergency landing, which could cause injury to the cabin crew and passengers and could impede a rapid evacuation.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1