TrackAD

Airworthiness directives › 2015-03-05

AD 2015-03-05 Airworthiness Directives; Airbus Airplanes

2015-03-25
2015-02-18
—
—
Airframe
—

Models named: A318-111, -112, -121, -122, A319-111, -113, -114, -115, -131, -132. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

(1) This AD applies to Airbus Model A318-111, -112, -121, and -122 airplanes; Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320-111, -211, -212, -214, -231, -232, and -233 airplanes; and Model A321-111, -112, -131, -211, -212, -213, -231, and -232 airplanes; certificated in any category; all manufacturer serial numbers, except airplanes identified in paragraph (c)(2) of this AD. (2) Airplanes that have been delivered from production with Airbus Modification 38209 (Removal of the Outer Wing Refueling Aperture) incorporated, and without Airbus Modification 38206 (Re-introduction of the Outer Wing Refueling Aperture) incorporated, are not affected by the requirements of this AD.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

This paragraph restates the requirements of paragraph (g) of AD 2012-09-07, Amendment 39-17042 (77 FR 28238, May 14, 2012), with revised repair approval language and revised service information. For Model A319-111, -112, and -132 airplanes; Model A320-111, -211, -212, -214 and -232 airplanes; and Model A321-111, -211, -212, and -231 airplanes; certificated in any category; having manufacturer serial numbers 0039, 0078, 0109, 0118, 0120, 0153, 0174, 0187, 0203, 0215, 0218, 0226, 0227, 0228, 0236, 0237, 0269, 0270, 0278, 0285, 0286, 0287, 0288, 0294, 0301, 0337, 0377, 0462, 0463, 0464, 0465, 0520, 0523, 0528, 0876, 0888, 0921, 0935, 0974, 1014, 1102, 1130, 1160, 1162, 1177, 1215, 1250, 1287, 1336, 1388, 1404, 1444, 1449, 1476, 1505, 1524, 1564, 1605, 1616, 1622, 1640, 1645, 1658, 1677, 1691, 1729, and 1905: Within 24 months after June 18, 2012 (the effective date of AD 2012-09-07), do an electrical bonding test to check for bonding between the re-fuel adaptor of the gravity fill and the top skin panels on the left-hand and right-hand wings, in accordance with the Accomplishment Instructions of Airbus Service Bulletin A320-57-1152, Revision 01, dated December 19, 2013. (1) If the resistance value is 10 milliohms or less at the left-hand and right-hand wing, no further action is required by this paragraph. (2) If the resistance value is greater than 10 milliohms at the left-hand or right-hand wing, before further flight, do a general visual inspection for corrosion of the component interface and adjacent area, in accordance with the Accomplishment Instructions of Airbus Service Bulletin A320-57-1152, Revision 01, dated December 19, 2013. If any corrosion is found during the inspection, before further flight, repair the gravity fill fuel adaptor, in accordance with the Accomplishment Instructions of Airbus Service Bulletin A320-57-1152, Revision 01, dated December 19, 2013; except where Airbus Service Bulletin A320-57-1152, Revision 01, dated December 19, 2013, specifies to contact Airbus, before further flight, repair using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA); or Airbus's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.

Unsafe condition

This AD was prompted by a determination that more airplanes are subject to the identified unsafe condition. We are issuing this AD to detect and correct corrosion and improper bonding, which, in combination with a lightning strike in this area, could create a source of ignition in a fuel tank, resulting in a fire or explosion and consequent loss of the airplane.

Affected ADs

This AD replaces AD 2012-09-07, Amendment 39-17042 (77 FR 28238, May 14, 2012).

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1