TrackAD

Airworthiness directives › 2015-17-13

AD 2015-17-13 Airworthiness Directives; The Boeing Company Airplanes

Superseded. This directive was replaced by AD 2016-11-07. Work to the current one.
2015-10-07
2015-09-02
39-18246
FAA-2014-0523
Airframe
2016-11-07

Models named: 777-200, -300 series. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to The Boeing Company Model 777-200 and -300 series airplanes, certificated in any category, equipped with Pratt & Whitney engines, as identified in Boeing Special Attention Service Bulletin 777-54-0027, Revision 1, dated September 12, 2013.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

At the applicable times specified in paragraph 1.E., “Compliance,” of Boeing Special Attention Service Bulletin 777-54-0027, Revision 1, dated September 12, 2013, except as provided by paragraph (h) of this AD, do the actions specified in paragraphs (g)(1) and (g)(2) of this AD, in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 777-54-0027, Revision 1, dated September 12, 2013. Repeat the functional check required by paragraph (g)(1) of this AD, thereafter at the applicable times specified in paragraph 1.E., “Compliance,” of Boeing Special Attention Service Bulletin 777-54-0027, Revision 1, dated September 12, 2013, until the terminating action specified in paragraph (i) of this AD is done. (1) Do a functional check for blockage of the forward strut drain line of the left and right strut and do all applicable corrective actions (including cleaning or replacing blocked drain tubes, repairing fluid leaks, and cleaning the inlet drain screen on the right system disconnect assembly inlet). Do all applicable corrective actions before further flight. Alternate tee fitting part numbers BACT16BR120612JN and AS4139J120612 may be used during the replacement of the forward strut drain lines, provided the installation is performed in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 777-54-0027, Revision 1, dated September 12, 2013. (2) Do a one-time cleaning of the smaller forward strut drain lines connected to the left systems disconnect, the strut forward lower spar, and the forward fire seal pan inlets.

Unsafe condition

This AD was prompted by reports of blocked drain lines at the engine forward strut that caused flammable fluid to accumulate in a flammable leakage zone. We are proposing this AD to detect and correct blockage of forward strut drain lines, which could cause flammable fluids to collect in the forward strut area and potentially cause an uncontrolled fire or cause failure of engine attachment structure and consequent airplane loss.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1