TrackAD

Airworthiness directives › 2016-13-15

AD 2016-13-15 Airworthiness Directives; Dassault Aviation Airplanes

2016-08-16
2016-07-12
39-18580
FAA-2016-3987
Airframe
—

Models named: FALCON 7X. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Dassault Aviation Model FALCON 7X airplanes, certificated in any category, manufacturer serial numbers 1 through 221 inclusive, except serial numbers 182 and 220.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Within 4,000 flight cycles or 98 months, whichever occurs first since date of issuance of the original airworthiness certificate or date of issuance of the original export certificate of airworthiness, do a detailed visual and rototest inspection of the bores, located on upper and lower stiffener joints to the web at pylon Frame 41, to determine if the bores are not satisfactory, in accordance with the Accomplishment Instructions of Dassault Service Bulletin 7X-346, dated April 24, 2015.

Unsafe condition

This AD was prompted by a report of improperly drilled bores, located on upper and lower stiffener joints to the web at a certain frame. We are issuing this AD to detect and correct an unsatisfactory bore that can adversely affect the structural integrity of the airplane.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1