TrackAD

Airworthiness directives › 2017-15-07

AD 2017-15-07 Airworthiness Directives; Safran Helicopter Engines, S.A., Turboshaft Engines

2017-08-08
2017-07-24
—
—
Engine
—

Applicability*9

This AD applies to all Safran Helicopter Engines, S.A., Arriel 1A1, 1A2, 1B, 1C, 1C1, 1C2, 1D, 1D1, 1E2, 1K1, 1S, and 1S1 turboshaft engines equipped with a drain valve assembly (DV) manufactured, repaired, or overhauled after December 31, 2015; with a diaphragm, part number 9 164 95 002 0, installed.

Compliance

Comply with this AD within the compliance times specified, unless already done. (1) Within 10 flight hours or 7 days, whichever occurs first, after the effective date of this AD, visually inspect the affected DV for fuel leakage: (i) If a fuel leak is detected, replace the affected DV with a DV eligible for installation, before the next flight. (ii) If no fuel leak is detected, before the next flight, wrap the affected DV with a self-amalgamate tape or heat shrinkable tubing using the Accomplishment Instructions, paragraph 2.4, in Safran Helicopter Engines Alert Mandatory Service Bulletin (MSB) No. A292 73 0853, Version A, dated April 7, 2017. (2) After wrapping an affected DV, as specified in paragraph (f)(1) of this AD, inspect the DV for fuel leakage before each first flight of the day. If a fuel leak is detected, replace the affected DV with a DV eligible for installation before the next flight. (3) If, during any inspection required by this AD, the wrapping is found defective (loose, missing, or damaged), before the next flight, remove the wrap and re-wrap the affected DV using the Accomplishment Instructions, paragraph 2.4, of Safran Helicopter Engines Alert MSB No. A292 73 0853, Version A, dated April 7, 2017. (4) If you replace the affected DV with another affected DV eligible for installation, you must still continue to perform the repetitive inspections required by paragraph (f)(2) of this AD.

Required actions

From the effective date of this AD, do not install any engine with an affected DV on any helicopter unless the DV has been wrapped and is leak-free in accordance with the instructions in paragraph 2.4 of Safran Helicopter Engines Alert MSB No. A292 73 0853, Version A, dated April 7, 2017.

Unsafe condition

This AD was prompted by reports of fuel leaks originating from the DV on certain Arriel engines. We are issuing this AD to prevent an engine compartment fire, in-flight shutdown, and damage to the helicopter.

Affected ADs

This AD replaces AD 2017-04-51, Amendment 39-18824 (82 FR 13753, March 15, 2017).

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1