Airworthiness directives › 2018-15-08
AD 2018-15-08 Airworthiness Directives; Pacific Aerospace Limited Airplanes
Makes named: pacific aerospace. Models named: 750XL. Read the applicability below — it usually turns on serial or part numbers too.
Applicability*9
This AD applies to Pacific Aerospace Limited Model 750XL airplanes, all serial numbers up to and including 215, certificated in any category.
Compliance
Unless already done, do the following actions in paragraphs (f)(1) and (2) of this AD: (1) Within 90 days after August 31, 2018 (the effective date of this AD), inspect the aft face of the firewall and determine if the sound insulation material is installed per the Inspection Instructions in Pacific Aerospace Service Bulletin PACSB/XL/095, Issue 1, dated December 21, 2017. (2) If a layer of black foam insulating material is found covering the firewall during the inspection required in paragraph (f)(1) of this AD, before further flight, remove the material per the Accomplishment Instructions in Pacific Aerospace Service Bulletin PACSB/XL/095, Issue 1, dated December 21, 2017.
Required actions
The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, Small Airplane Standards Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Mike Kiesov, Aerospace Engineer, FAA, Small Airplane Standards Branch, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4144; fax: (816) 329-4090; email: mike.kiesov@faa.gov . Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. (2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, Small Airplane Standards Branch, FAA; or the Civil Aviation Authority of New Zealand (CAA).
Unsafe condition
This AD was prompted by mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and address an unsafe condition on an aviation product. The MCAI describes the unsafe condition as airplane sound insulation materials attached to the aft face of the firewall not complying with the applicable burn testing criteria for materials on the cabin side of the firewall. We are issuing this AD to prevent the spread of fire into the cabin in case of an engine fire.
Affected ADs
None.
Read the original on the Federal Register →
You just looked this one up by hand
TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.
- Bring your existing list in from a spreadsheet Paste the rows straight out of Excel. Headers like C/W Date and N/A are read for you.
- A copy that works when this does not One file. No internet, no login, no this software running. For the morning something has to be produced and the computer is not cooperating.
- $5 a month, or $50 a year Up to 50 aircraft on either.
Look round a real shop first Start free
The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.
The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1