TrackAD

Airworthiness directives › 2019-08-01

AD 2019-08-01 Airworthiness Directives; RECARO Aircraft Seating GmbH & Co. KG

2019-05-21
2019-05-06
39-19622
FAA-2018-1019
Airframe
—

Models named: A318, A319, A320. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

(1) This AD applies to RECARO Aircraft Seating GmbH & Co. KG (RECARO) Model 3510A and 3510D passenger seats. (2) These appliances are installed on, but not limited to, Airbus SAS Model A318, A319, and A320 airplanes.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Within 2,700 flight hours (FHs) or 945 flight cycles (FCs), whichever occurs first, after the effective date of this AD, modify the affected passenger seat and re-identify each modified passenger seat as follows: (1) Review the seat part numbers (P/Ns) identified in Table 1 to paragraph (g)(1) of this AD to identify the applicable service bulletin (SB). BILLING CODE 4910-13-P ER06MY19.000 BILLING CODE 4910-13-C (2) For seats identified by RECARO SB No. 3510-25-609, Original Issue, dated June 20, 2016 (“RECARO SB No. 3510-25-609”): (i) Review Planning Information, paragraph 1.A., Tables 2 and 3, in RECARO SB No. 3510-25-609, to determine if a modification is required for the specific P/N seat. (ii) Follow the Accomplishment Instructions, paragraphs 3.A., 3.B., 3.C., 3.D., and 3.E. in RECARO SB No. 3510-25-609. (3) For seats identified by RECARO SB No. 3510-25-752, Original Issue, dated May 20, 2016 (“RECARO SB No. 3510-25-752”): (i) Review Planning Information, paragraph 1.A., Tables 2 and 3, in RECARO SB No. 3510-25-752, to determine if a modification is required for the specific P/N seat. (ii) Follow the Accomplishment Instructions, paragraphs 3.A., 3.B., 3.C., 3.D., and 3.E. in RECARO SB No. 3510-25-752. (4) For seats identified by RECARO SB No. 3510-25-753, Original issue, dated June 23, 2016 (“RECARO SB No. 3510-25-753”): (i) Review Planning Information, paragraph 1.A., Tables 2 and 3, in RECARO SB No. 3510-25-753, to determine the required modification for the specific P/N seat. (ii) Follow the Accomplishment Instructions, paragraphs 3.A., 3.B., 3.C., 3.D., and 3.E. in RECARO SB No. 3510-25-753.

Unsafe condition

This AD was prompted by an analysis that the affected RECARO model passenger seats contain a seat pan assembly design that can trap a person using the seat to assist during an emergency evacuation. We are issuing this AD to prevent passenger entrapment in the event a person climbs on a seat to assist during an emergency evacuation. The unsafe condition, if not addressed, could result in possible passenger entrapment, injury, or delay in the case of emergency evacuation.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1