TrackAD

Airworthiness directives › 2019-14-07

AD 2019-14-07 Airworthiness Directives; Airbus SAS Airplanes

2019-09-12
2019-08-08
39-19685
FAA-2019-0251
Airframe
—

Models named: A320-251N, -271N, A321-251N, -253N, -272N. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Airbus SAS Model A320-251N and -271N airplanes; and Model A321-251N, -253N, -271N, and -272N airplanes; certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2019-0081, dated April 3, 2019 (“EASA AD 2019-0081”).

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2019-0081.

Unsafe condition

This AD was prompted by a report that during a calibration check, some torqueing tools used on the final assembly line have been found out of tolerance. The FAA is issuing this AD to address connections of sense and fire extinguishing lines within the pylon area that have been under-torqued, which could lead to leaks or disconnections of those lines and possibly result in reduced engine control and reduced safety margin in case of engine fire.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1