TrackAD

Airworthiness directives › 2019-16-03

AD 2019-16-03 Airworthiness Directives; Airbus SAS Airplanes

2019-09-06
2019-08-22
39-19706
FAA-2019-0606
Airframe
—

Models named: A350-941, -1041. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Airbus SAS Model A350-941 and -1041 airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2019-0175, dated July 19, 2019 (“EASA AD 2019-0175”).

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2019-0175.

Unsafe condition

This AD was prompted by a report of a front engine mount primary pin which moved axially out of place; investigation revealed that incorrect washers had been installed on the engine mount pins. The FAA is issuing this AD to address disengagement of a primary engine mount pin, which, along with an additional failure of the “fail-safe” link pin, could result in the in-flight detachment of an engine, and consequent reduced control of the airplane.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1