TrackAD

Airworthiness directives › 2019-19-05

AD 2019-19-05 Airworthiness Directives; Airbus SAS Airplanes

2019-11-13
2019-10-09
39-19741
FAA-2019-0401
Airframe
—

Models named: A350-941, -1041. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to all Airbus SAS Model A350-941 and -1041 airplanes, certificated in any category.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2018-0243, dated November 8, 2018 (“EASA AD 2018-0243”). All provisions specified in EASA AD 2018-0243 apply in this AD. Note 1 to paragraph (g): Instructions for re-identification of each affected BCD are provided in paragraph (2) of EASA AD 2018-0243. They can also be found in Airbus Service Bulletin A350-52-P015, Revision 01, dated November 12, 2018.

Unsafe condition

This AD was prompted by reports of disconnections of certain hinge arms of the bulk cargo door (BCD) due to disbonding of the hinge arm bushes. The FAA is issuing this AD to address disconnected hinge arms, which, in a case of ditching, could result in the BCD opening inward and allowing water into the cargo hold, and consequent reduced flotation time.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1