TrackAD

Airworthiness directives › 2019-19-14

AD 2019-19-14 Airworthiness Directives; Airbus SAS Airplanes

2019-11-14
2019-10-10
39-19750
FAA-2019-0194
Airframe
—

Models named: A350-941, -1041. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to all Airbus SAS Model A350-941 and -1041 airplanes, certificated in any category.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Aviation Safety Agency (EASA) AD 2019-0020, dated January 31, 2019 (“EASA AD 2019-0020”).

Unsafe condition

This AD was prompted by reports of cracks within the ring gears of a slat geared rotary actuator (SGRA), resulting from a change in the raw material manufacturing process. The FAA is issuing this AD to address cracking of SGRA ring gears. This condition, if not detected and corrected, could, in combination with an independent failure on the second SGRA of the same slat surface, lead to detachment of the slat surface, possibly resulting in reduced control of the airplane and injury to persons on the ground.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1