TrackAD

Airworthiness directives › 2019-20-12

AD 2019-20-12 Airworthiness Directives; Airbus SAS Airplanes

2019-11-26
2019-10-22
39-19765
FAA-2019-0580
Airframe
—

Models named: A330-243, -243F, -341, -342, -343. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to all Airbus SAS Model A330-243, -243F, -341, -342, and -343 airplanes, certificated in any category.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2019-0031, dated February 13, 2019 (“EASA AD 2019-0031”).

Unsafe condition

This AD was prompted by a determination that cracks can develop on the ripple damper weld of the hydraulic pressure tube assembly and reports of failure of the ripple damper of the hydraulic pressure tube assembly. The FAA is issuing this AD to address cracking of the ripple damper weld of the hydraulic pressure tube assembly, which could lead to hydraulic fluid leakage and consequent loss of the green hydraulic system. This condition, if combined with other system failures, could result in reduced control of the airplane.

Affected ADs

This AD affects AD 2017-07-03, Amendment 39-18841 (82 FR 15985, March 31, 2017; corrected April 13, 2017 (82 FR 17749)) (“AD 2017-07-03”).

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1