TrackAD

Airworthiness directives › 2019-26-01

AD 2019-26-01 Airworthiness Directives; Airbus SAS Airplanes

Superseded. This directive was replaced by AD 2022-03-22. Work to the current one.
2020-02-28
2020-01-24
39-21023
FAA-2019-0723
Airframe
2022-03-22

Models named: A350-941, -1041. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Airbus SAS Model A350-941 and -1041 airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2019-0206, dated August 20, 2019 (“EASA AD 2019-0206”).

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2019-0206.

Unsafe condition

This AD was prompted by reports of sealant bead damage caused by rotation of the attachment fitting bearing assembly of a trimmable horizontal stabilizer (THS). The FAA is issuing this AD to address possible water ingress due to sealant bead damage, which could result in corrosion damage in the aluminum corner fitting. This condition, if not addressed, could lead to detachment and loss of the THS, possibly resulting in loss of control of the airplane and injury to persons on the ground.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1