TrackAD

Airworthiness directives › 2020-03-21

AD 2020-03-21 Airworthiness Directives; Bombardier, Inc, Airplanes

2020-03-12
2020-02-26
39-19845
FAA-2020-0100
Airframe
—

Models named: BD-700-1A10, BD-700-1A11. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to Bombardier, Inc., Model BD-700-1A10 and BD-700-1A11 airplanes, certificated in any category, serial numbers 9001 through 9879 inclusive and 9998 and serial numbers 60001 and subsequent.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

For the purposes of this AD, an affected MLG trailing arm assembly is a MLG trailing arm assembly with part number 21410-107 and a serial number listed in Appendix 4, Table 1 of the applicable Bombardier service information specified in figure 1 to paragraphs (g) through (k) and (m) of this AD. ER26FE20.008

Unsafe condition

This AD was prompted by reports that main landing gear (MLG) trailing arm assemblies were found with compromised paint finish and corrosion on the axle bore inner diameters due to improper removal of contaminants during manufacturing. The FAA is issuing this AD to address possible corrosion on the inner diameter of the MLG trailing arm assembly axle bore, which, if not detected and corrected, could lead to MLG collapse.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1