TrackAD

Airworthiness directives › 2020-18-05

AD 2020-18-05 Airworthiness Directives; Pratt & Whitney Canada Corp. Turboshaft Engines

2020-10-07
2020-09-02
39-21226
FAA-2020-0471
Engine
—

Applicability*9

This AD applies to Pratt & Whitney Canada Corp. (P&WC) PT6B-37A model turboshaft engines with engine serial number PCE-PU0289 and earlier, which do not have an installed fuel control unit (FCU) that incorporates a stainless steel air adapter using P&WC Service Bulletin (SB) No. PT6B-72-39107, Revision No. 1, dated December 13, 2017.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Within the compliance time identified in Table 1 to paragraph (g) of this AD, replace the FCU with an FCU that incorporates the stainless steel air adapter using the Accomplishment Instruments, paragraphs 3.A. and 3.C., of P&WC SB No. PT6B-72-39107, Revision No. 1, dated December 13, 2017. ER02SE20.001

Unsafe condition

This AD was prompted by a report of contamination from galvanic corrosion between the FCU aluminum body and the steel union fitting causing the loss of engine control, resulting in an engine over-speed condition and subsequent in-flight shutdown (IFSD). The FAA is issuing this AD to prevent failure of the FCU due to contamination from galvanic corrosion. The unsafe condition, if not addressed, could result in loss of engine control, failure of the engine, IFSD, and loss of the helicopter.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1