TrackAD

Airworthiness directives › 2020-23-12

AD 2020-23-12 Airworthiness Directives; Airbus SAS Airplanes

2020-12-03
2020-11-18
39-21328
FAA-2020-1019
Airframe
—

Models named: A350-1041. Read the applicability below — it usually turns on serial or part numbers too.

Applicability*9

This AD applies to all Airbus SAS Model A350-1041 airplanes, certificated in any category.

Compliance

Comply with this AD within the compliance times specified, unless already done.

Required actions

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2020-0126, dated June 3, 2020 (“EASA AD 2020-0126”).

Unsafe condition

This AD was prompted by report that, during testing, wear was found on the drive strut anti-rotation knuckles and lever bearing assembly (LBA) bushes on a certain flap station. The FAA is issuing this AD to address wear and corrosion damage in the primary structure, which could result in detachment of the outer flap during flight and possible damage to or reduced control of the airplane.

Affected ADs

None.

Read the original on the Federal Register →

You just looked this one up by hand

TrackAD holds all 12,278 of them and matches them against the aircraft you actually look after — airframe, engine, propeller and appliances in one pass — then works out what falls due and when.

Look round a real shop first Start free

The demonstration shop is eleven real aircraft with a year of work behind them. No account needed.

The directive text above is reproduced from the Federal Register, a work of the United States government and in the public domain. The separation into applicability, compliance and required actions is TrackAD's.*1